LIU Ji-qiang, ZHANG Gai-li, HUANG Jiao-ying, et al. Location analysis of neutron single particle fault source based on improved FMECA and fault propagation model[J]. 2020, 37(8): 32-36.
LIU Ji-qiang, ZHANG Gai-li, HUANG Jiao-ying, et al. Location analysis of neutron single particle fault source based on improved FMECA and fault propagation model[J]. 2020, 37(8): 32-36.DOI:
Location analysis of neutron single particle fault source based on improved FMECA and fault propagation model
With the continuous development of components processing technology
the size of components unit is constantly reduced
and the working voltage is constantly reduced
so that the components ability to resist single event effect is constantly reduced. This paper analyzes the fault propagation mechanism of the airborne data acquisition computer for an unmanned aerial vehicle (uav) under atmospheric neutron radiation. Combined with the improved FMECA method
based on the cause failure
the result failure and the contribution rate of the cause failure to the result failure
the fault propagation diagram of the computer is established
and the probability of occurrence of each underlying failure mode is obtained through layer-by-layer reasoning. A possible high-risk source location method is proposed. The possible high-risk fault source located at the system level is the core device FPGA of two single-boards on the computer.
关键词
Keywords
references
HEIJMEN T, REMI G, SLAYMAN C, et al. Soft Errors in Modern Electronic Systems[M]. Springer US, 2011: 55-76.
NORMAND E, DOMINIK L. Cross Comparison Guide for Results of Neutron SEE Testing of Microelectronics Applicable to Avionics[C]// 2010 IEEE Radiation Effects Data Workshop, Denver, CO, USA: IEEE, 2010: 8-8.
ZHANG M J.Research on fault neutron induced single event effect caused by propagation mechanism of airborne electronic equipment[D].Beijing: Beijing University of Aeronautics and Astronautics, 2018.
IEC 62396-2, Process Management for avionics: Atmosphere Radiation Effects. Part2: Guidelines for Single Event Effects Testing for Avionics Systems[S].Switzerland, The InternationalElectrotechnical Commission (IEC), 2011.
YANG W T, LI Y H, LI Y, et al. Atmospheric neutron single event effect test on Xilinx 28 nm system on chip at CSNS-BL09[J]. Microelectronics Reliability, 2019, 99(8):119-124. DOI: 119
WANG Y H, DENG C, WU J, et al. A corrective maintenance scheme for engineering equipment[J]. Engineering Failure Analysis, 2014, 36(1):269-283. DOI: 269
ZHANG H Q, SHAO X D, SUN C, et al. Integrated fault diagnosis method based on improved FMEA and failure propagation model[J]. Mechanical Science and Technology for Aerospace Engineering, 2017, 36(1):23-28. DOI: 23
WANG H Z, LI G S. Demand analysis method of electronic equipment fault diagnosis based on FMECA[J]. Ordnance Industry Automation, 2018, 37(9):29-31. DOI: 29
ZOU A N, WANG H J, GAO Y J.Reliability evaluation and promotion of machine tool running based on improved FMECA[J]. Journal of Beijing Information Science % Technology University, 2018, 33(3):31-35. DOI: 31