EMBEDDED STRUCTURE OF RECIRCULATION ZONES IN COAXIAL DUMP COMBUSTOR WITH INNER SWIRL INLET
|更新时间:2026-07-07
|
EMBEDDED STRUCTURE OF RECIRCULATION ZONES IN COAXIAL DUMP COMBUSTOR WITH INNER SWIRL INLET
Vol. 6, Issue 1, (1991)
作者机构:
航空航天部第三十一所
作者简介:
基金信息:
DOI:
CLC:
Published:1991
稿件说明:
移动端阅览
Yu Qiang, Liu Xingzhou, Situ Min, et al. EMBEDDED STRUCTURE OF RECIRCULATION ZONES IN COAXIAL DUMP COMBUSTOR WITH INNER SWIRL INLET[J]. 1991, 6(1).
DOI:
Yu Qiang, Liu Xingzhou, Situ Min, et al. EMBEDDED STRUCTURE OF RECIRCULATION ZONES IN COAXIAL DUMP COMBUSTOR WITH INNER SWIRL INLET[J]. 1991, 6(1).DOI:
EMBEDDED STRUCTURE OF RECIRCULATION ZONES IN COAXIAL DUMP COMBUSTOR WITH INNER SWIRL INLET
The new swirling chamber designed by combining swirlers with bluff bodies is considered in this paper.The cold flowfields in the coaxial dump combustor with inner swirl inlet were measured and investigated by using five-hole probes.It is found that when the flow ratio of the swirling chamber to the outer annular channel decreases and the expansion ability of outer annular flows toward the combustor wall is enhanced
a two-dimensional axisymmetrical central recirculation zone without tangential velocities occurs behind it in the dump combustor in addition to the swirling chamber recirculation zone.Both recirculation zones are embedded in each other.The swirling chamber recirculation zone not only tends to create the central recirculation zone
but also generates the suction which makes the latter bigger and stronger.Experimental results of combustion show that the high combustion efficiency is obtained as the embedded structure exists.