Numerical Investigation of Boundary Layer Suction in Compressor Cascade with Large Turning Angles
|更新时间:2026-07-07
|
Numerical Investigation of Boundary Layer Suction in Compressor Cascade with Large Turning Angles
Vol. 20, Issue 4, (2005)
作者机构:
哈尔滨工业大学能源科学与工程学院,哈尔滨,150001
作者简介:
基金信息:
DOI:
CLC:
Published:2005
稿件说明:
移动端阅览
SONG Yan-ping, CHEN Fu, ZHAO Gui-jie, et al. Numerical Investigation of Boundary Layer Suction in Compressor Cascade with Large Turning Angles[J]. 2005, 20(4).
DOI:
SONG Yan-ping, CHEN Fu, ZHAO Gui-jie, et al. Numerical Investigation of Boundary Layer Suction in Compressor Cascade with Large Turning Angles[J]. 2005, 20(4).DOI:
Numerical Investigation of Boundary Layer Suction in Compressor Cascade with Large Turning Angles
Numerical study of the effects of suction location and suction flow rate on performance of low-speed compressor cascade with large turning angles shows that with the same inlet Mach number
the optimal suction location
corresponding to the least cascade total loss
exists at a lower suction flow rate
and the decrease of total loss is not sensitive to the suction location at a higher level of suction flow rate.As suction flow rate increases
the accumulation of low energy fluid in the suction corner is alleviated
and the flow turning as well as the cascade load increases
therefore
total loss is reduced by 28.2% at most.The diffusion recovery due to the boundary layer suction and the separation of passage vortex are two main factors for the selection of the optimal suction location and suction flow rate.