Theoretical investigation on starting performance of supersonic ejector with secondary throat

WU Ji-ping; WANG Zhen-guo

Chinese

您当前的位置：

首页 >

文章列表页 >

Theoretical investigation on starting performance of supersonic ejector with secondary throat

更新时间：2026-07-07

- Theoretical investigation on starting performance of supersonic ejector with secondary throat
- Vol. 23, Issue 5, (2008)
- 作者机构：
  
  国防科技大学航天与材料工程学院,长沙,410073
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2008
- 稿件说明：
移动端阅览
WU Ji-ping, WANG Zhen-guo. Theoretical investigation on starting performance of supersonic ejector with secondary throat[J]. 2008, 23(5).
DOI：

WU Ji-ping, WANG Zhen-guo. Theoretical investigation on starting performance of supersonic ejector with secondary throat[J]. 2008, 23(5). DOI：

摘要

为了给带第二喉道的超声速引射器的工程设计提供设计依据

提出了一套快速分析其启动性能的方法.该方法采用特征线方法分析一次流喷嘴出口流场

结合Korst再压缩判据确定引射器盲腔压力

采用一维控制体方法计算第二喉道引射器的下游流场.采用该方法可以较好地估计第二喉道极限面积比、最小启动压比以及对应的盲腔压力.研究了一次流物性参数比热比和3个几何参数对引射器启动性能的影响.结果表明:该启动性能分析方法具有较好的一致性;较低的盲腔压力对应较高的最小启动压比.

Abstract

A set of fast analysis methods for starting performance of second-throat supersonic ejector was presented.The method of characteristics was introduced to calculate the flow field after the primary nozzle exit

whilst Korst's recompression criterion was adopted to determine the corresponding cell pressure

and one-dimensional control volume method was employed to analyze the downstream flow field.The second-throat area ratio limit

the minimal starting pressure ratio and the corresponding cell pressure were obtained.The influences of primary flow specific heat ratio and three geometric parameters on the starting performance were investigated.The results indicate that lower cell pressure leads to higher minimal starting pressure ratio

and the consistency of the method is quite well.

关键词

Keywords

references

Views

493

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Prediction method on equivalent thermal conductivity coefficient of plain braided C/SiC composites material based on finite element method

Aerodynamic characteristics of design Mach number of 5 two-dimensional inlet with mixed-compression under typical condition

Computation of effect of different nozzle parameters on internal performance of convergent-divergent axisymmetric nozzle

Study of novel flow control concept for fix-geometry two-dimensional mix-compression supersonic inlet

Numerical simulation of priming process of propellant pipelines

Related Author

LU Si-da

GAO Xi-guang

SONG Ying-dong

WENG Xiao-chai

GUO Rong-wei

ZHU Dan-dan

SHAO Wan-ren

WENG Xiao-chai

Related Institution

Jiangsu Province Key Laboratory of Aerospace Power System, College of Energy and Power Engineering, Nanjing University of Aeronautics and Astronautics

Department of Power and Propulsion, School of Engineering, Cranfield University, Bedfordshire MK4

State Key Laboratory of Mechanics and Control of Mechanical Structures, Nanjing University of Aeronautics and Astronautics

Unit 94710, the Chinese People's Liberation Army

Innovation Center for Advanced Aero-Engine

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰