Experimental research on film cooling characteristics of cylindrical hole and expanding hole on the leading edge

ZHU Hui-ren; ZHANG Xia; LIU Cun-liang

Chinese

您当前的位置：

首页 >

文章列表页 >

Experimental research on film cooling characteristics of cylindrical hole and expanding hole on the leading edge

更新时间：2026-07-07

- Experimental research on film cooling characteristics of cylindrical hole and expanding hole on the leading edge
- Vol. 25, Issue 7, (2010)
- 作者机构：
  
  西北工业大学动力与能源学院,西安,710072
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2010
- 稿件说明：
移动端阅览
ZHU Hui-ren, ZHANG Xia, LIU Cun-liang. Experimental research on film cooling characteristics of cylindrical hole and expanding hole on the leading edge[J]. 2010, 25(7).
DOI：

ZHU Hui-ren, ZHANG Xia, LIU Cun-liang. Experimental research on film cooling characteristics of cylindrical hole and expanding hole on the leading edge[J]. 2010, 25(7). DOI：

摘要

采用考虑曲率影响的瞬态液晶测量技术测量了叶片前缘扩张形孔和圆柱形孔的气膜冷却特性

分析了不同孔形在不同平均吹风比下气膜冷却效率的局部分布特征及定量变化关系

结果表明:①与圆柱形孔相比

扩张形孔射流的覆盖面更大

主要覆盖区域的偏移角度更小;②圆柱形孔的平均冷却效率在不同测量区域内均随平均吹风比的增加先升高后下降

扩张形孔的平均冷却效率在孔排间区域随平均吹风比的增加单调升高

在第二排孔后区域各平均吹风比下基本一致;③在实验范围内

扩张形孔的展向平均冷却效率较高.

Abstract

Film cooling characteristics of expanding hole and cylindrical hole on the leading edge were measured using a transient liquid crystal measurement technique considering the influence of curvature.Local distribution characteristics and quantitative relationships of different holes' film cooling effectiveness were analyzed under different average blowing ratios.The results show that:(1) As compared with the cylindrical hole

the expanding hole jet has a larger coverage

the offset angle of the main coverage area is smaller.(2) In different test regions

the average cooling effectiveness of cylindrical hole rises firstly and then decreases with increasing average blowing ratio.In the region between the first and second row of holes

the average cooling effectiveness of expanding hole monotonously increases with average blowing ratio.In the downstream region after the second-row holes

the average cooling effectiveness of expanding hole is basically the same under all average blowing ratios.(3) Within the experimental range

the laterally averaged effectiveness of expanding hole is much larger than that of cylindrical hole.

关键词

Keywords

references

Views

396

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effects of blowing ratio on turbine vane suction side film cooling under different turbulence intensity conditions

Experimental investigation on effect of small auxiliary holes on film cooling effectiveness

Experimental research on film cooling characteristics of cylindrical hole with transient liquid crystal measurement technique

Flow and heat transfer characteristics of round⁃hole film cooling with crater

Numerical study on effect of film ejections in rotating detonation engine combustor

Related Author

贺宜红

刘存良

宋辉

朱惠人

周志翔

LIU Xiao-hong

TAO Zhi

LUO Xiang

Related Institution

中国航空发动机集团有限公司湖南动力机械研究所

西北工业大学动力与能源学院

National Key Laboratory of Science and Technology on Aero-Engine Aero-thermodynamics,School of Jet Propulsion, Beijing University of Aeronautics and Astronautics

Department of Thermal Science and Energy Engineering，University of Science and Technology of China

Shenyang Engine Research Institute，Aero Engine Corporation of China

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰