Experimental investigation on effect of small auxiliary holes on film cooling effectiveness

LIU Xiao-hong; TAO Zhi; LUO Xiang

Chinese

您当前的位置：

首页 >

文章列表页 >

Experimental investigation on effect of small auxiliary holes on film cooling effectiveness

更新时间：2026-07-07

- Experimental investigation on effect of small auxiliary holes on film cooling effectiveness
- Vol. 26, Issue 12, (2011)
- 作者机构：
  
  北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室,北京,100191
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2011
- 稿件说明：
移动端阅览
LIU Xiao-hong, TAO Zhi, LUO Xiang. Experimental investigation on effect of small auxiliary holes on film cooling effectiveness[J]. 2011, 26(12).
DOI：

LIU Xiao-hong, TAO Zhi, LUO Xiang. Experimental investigation on effect of small auxiliary holes on film cooling effectiveness[J]. 2011, 26(12). DOI：

摘要

采用稳态液晶测温方法

详细研究了具有辅助小孔的分叉孔和大小孔的冷却效率分布规律

并与圆柱孔和扇形孔进行对比

分析小孔辅助结构对气膜冷却效果的影响.实验参数:主流雷诺数为2900

吹风比为0.3~3.0

密度比为1.06.结果表明:所有工况下

小孔辅助结构均在一定程度上提高气膜冷却效果

吹风比越大

对气膜冷却效果的改善就越明显

并且大小孔的冷却效率始终高于分叉孔.扇形孔只在吹风比大于1.0时

才起到改善气膜冷却效果的作用.

Abstract

Experimental study was conducted to investigate the effect of small auxiliary holes on the film cooling performance.The steady-state thermochromic liquid crystal (TLC) method was used to obtain the adiabatic effectiveness distributions on the flat surface.Measurements of adiabatic effectiveness were presented for cylindrical hole

fan-shaped hole

furcated hole and parallel hole with main flow Reynolds number at 2900

blowing ratio ranging from 0.3 to 3.0 and density ratio at 1.06.Results show that the film coverage and adiabatic effectiveness downstream of furcated hole and parallel hole are evidently superior to those of cylindrical hole at blowing ratios range from 0.3 to 3.0.While fan-shaped hole increases the adiabatic effectiveness compared with cylindrical hole only in cases of blowing ratios greater than 1.0.A higher blowing ratio means more obvious improvement of the adiabatic effectiveness.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental and numerical studies on the film cooling characteristics of anisotropic composite plates

Effects of blowing ratio on turbine vane suction side film cooling under different turbulence intensity conditions

Numerical research on film cooling effectiveness with different mainstream pressure gradient

Numerical investigation of shaped-hole film cooling on turbine rotor blade

Influence of blowing ratio on film cooling of rotating turbine blade

Related Author

侯亚东

单勇

李江宁

张靖周

谭晓茗

贺宜红

刘存良

宋辉

Related Institution

南京航空航天大学能源与动力学院江苏省航空动力系统重点实验室

中国航空发动机集团有限公司沈阳发动机研究所

中国航空发动机集团有限公司湖南动力机械研究所

西北工业大学动力与能源学院

中国航空发动机集团有限公司四川燃气涡轮研究院

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰