Separation performance of hollow fiber membrane for on-board inerting gas generating system
|更新时间:2026-07-07
|
Separation performance of hollow fiber membrane for on-board inerting gas generating system
Vol. 27, Issue 6, (2012)
作者机构:
1. 南京航空航天大学 航空宇航学院,南京,210016
2. 中国航空工业集团公司 中航工业第一飞机设计研究院,西安,710089
作者简介:
基金信息:
DOI:
CLC:
Published:2012
稿件说明:
移动端阅览
FENG Shi-yu, LU Ji, LIU Wei-hua, et al. Separation performance of hollow fiber membrane for on-board inerting gas generating system[J]. 2012, 27(6).
DOI:
FENG Shi-yu, LU Ji, LIU Wei-hua, et al. Separation performance of hollow fiber membrane for on-board inerting gas generating system[J]. 2012, 27(6).DOI:
Separation performance of hollow fiber membrane for on-board inerting gas generating system
The mathematical model of the hollow fiber membrane of on-board inert gas generation system (OBIGGS) is set up in term of the differential method
and solved by the Runge-Kutta method.The comparison between calculating results and experimental data published in literature reveals that the deviation is within 10%.Furthermore
this theoretical model is employed to analyze the influence of the specific feed flux of membrane area
pressure ratio of membrane fiber
the separation factor and the permeability coefficient to the volume fraction of oxygen in production gas and the production efficiency of nitrogen.The study shows that though the increase of the specific feed flux of membrane area could positively promote the production efficiency of nitrogen
the volume fraction of oxygen reduces sharply.Hence
an appropriate process of OBIGGS should be designed to overcome the disadvantage mentioned above.The increase of the pressure ratio and the permeability coefficient of oxygen will decrease the production efficiency of nitrogen and the volume fraction of oxygen
but the influence of the permeability coefficient is slight.Therefore
the increase of the permeability coefficient of oxygen is beneficial to the separation performance.Based on the experimental data and the model
the change of the separation ideal level related to the temperature and pressure is analyzed
the result shows that the pressure ratio will make greater effect on the separation ideal level.When the pressure ratio increases
the actual separation process will deviate from the theoretical one gradually.