Submerged inlet performance improvement with blowing on fuselage

CHENG Dai-shu; SUN Shu; WEN Yu-fen; TAN Hui-jun

Chinese

您当前的位置：

首页 >

文章列表页 >

Submerged inlet performance improvement with blowing on fuselage

更新时间：2026-07-07

- Submerged inlet performance improvement with blowing on fuselage
- Vol. 27, Issue 5, (2012)
- 作者机构：
  
  1. 南京航空航天大学能源与动力学院,南京,210016
  2. 南京航空航天大学民航学院,南京,210016
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2012
- 稿件说明：
移动端阅览
CHENG Dai-shu, SUN Shu, WEN Yu-fen, et al. Submerged inlet performance improvement with blowing on fuselage[J]. 2012, 27(5).
DOI：

CHENG Dai-shu, SUN Shu, WEN Yu-fen, et al. Submerged inlet performance improvement with blowing on fuselage[J]. 2012, 27(5). DOI：

摘要

针对埋入式进气道进口处吸入了大量的弹身边界层低能流而导致的总压恢复系数较低

出口流场畸变较大的问题

提出了一种基于弹体表面吹气的埋入式进气道流场控制概念

并采用数值仿真先对不带进气道的纯弹身模型进行了边界层控制研究

而后进一步对完整的进气道/弹身模型进行了仿真分析

获得了吹气控制措施对埋入式进气道流动结构和工作性能的影响特性.结果表明:合适的吹气方案确实能够有效地吹除部分弹身边界层

改善埋入式进气道进口前的边界层状况及内通道流态

提高其总压恢复系数并降低出口流场畸变.设计状态下埋入式进气道的总压恢复系数提高了1.5%

畸变指数降低了6.6%.

Abstract

Due to the large amount of boundary layer ingested into the submerged inlet which results in low total pressure recovery and high flow distortion

a flow control method based on blowing on the fuselage was introduced.By computational method

the models without and with inlet were both studied to obtain the effects of blow technique on the performance and flow structure of submerged inlet.Results indicate that the control method is effective to blow fuselage boundary layer

and improve the boundary layer condition before entrance and the flow in the duct.At the design condition

the total pressure recovery coefficient increased by 1.5% and the distortion index decreased by 6.6% as compared with the baseline case.

关键词

Keywords

references

Views

652

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Comparison on aerodynamic and stealthy performanceof flying wing unmanned aerial vehicle withthree conformal intake inlets

Experimental investigation of pneumatic characteristics for S-shaped inlet in missiles

Experimental and numerical simulation on aerodynamic performance of large radius change to length ratio intermediate casing

Generation conditions of streamwise vortex in supersonic flat⁃plate boundary layer

Flow and heat transfer characteristics of round⁃hole film cooling with crater

Related Author

ZHANG Le

ZHOU Zhou

XU Xiao-ping

WANG Hong-bo

JING Jian-peng

GUO Rong-wei

Jianming LIU

Shengchun HAO

Related Institution

State Key Laboratory of UAV Special Technology, Northwestern Polytechnical University

Military Representative Office of Chinese People's Liberation Army Residing in Xi'an Aircraft Company

Shenyang Engine Research Institute，Aero Engine Corporation of China

Department of Mechanics，School of Mechanical Engineering，Tianjin University

Department of Thermal Science and Energy Engineering，University of Science and Technology of China

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰