Flow separation control of lobed ejector/forced mixer by ventilation

PAN Cheng-xiong; ZHANG Jing-zhou; SHAN Yong; WANG Xian-wei

Chinese

您当前的位置：

首页 >

文章列表页 >

Flow separation control of lobed ejector/forced mixer by ventilation

更新时间：2026-07-07

- Flow separation control of lobed ejector/forced mixer by ventilation
- Vol. 28, Issue 2, (2013)
- 作者机构：
  
  1. 南京航空航天大学能源与动力学院,南京,210016
  2. 中国航空工业集团公司中国直升机设计研究所,江西,景德镇,333001
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2013
- 稿件说明：
移动端阅览
PAN Cheng-xiong, ZHANG Jing-zhou, SHAN Yong, et al. Flow separation control of lobed ejector/forced mixer by ventilation[J]. 2013, 28(2).
DOI：

PAN Cheng-xiong, ZHANG Jing-zhou, SHAN Yong, et al. Flow separation control of lobed ejector/forced mixer by ventilation[J]. 2013, 28(2). DOI：

摘要

为了抑制大扩张角波瓣混合器主流侧瓣顶内存在的流动分离现象

在基准波瓣混合器上开设了通气狭缝

通过数值模拟的方法研究了上述处理对次流分别为受迫流动和引射流动两种情况下的波瓣混合器抑制主流流动分离的效果.研究结果表明:①波瓣扩张角小于35°时

波瓣混合器内没有任何的流动分离的现象发生

当波瓣扩张角增大到35°时

波瓣内开始出现流动分离

继续增大波瓣扩张角

则波瓣混合器内流动分离加大;②对于次流为受迫流动的大波瓣扩张角波瓣混合器而言

开设了通气狭缝后

流动分离得到了有效的抑制;③对于次流为引射流动的波瓣混合器而言

对存在流动分离的大波瓣扩张角波瓣混合器开设了通气狭缝后

流动分离并未得到了有效的抑制

通气狭缝的存在提前诱发主流侧流体的分离.

Abstract

To control flow separation inside the lobed mixer with a big lobed angle

ventilating treatment was performed on a baseline lobed mixer to reveal the effectiveness of ventilation on eliminating separation bubble inside the lobed mixer when secondary flow is forced or ejected by numerical simulation. Results show that:(1)When the lobed angle is below 35 degrees

no separation is observed; when the lobed angle is at 35 degrees

separation bubble begin to appear inside the lobed nozzle

when the lobed angle is above 35 degrees

separation bubble augments.(2)Ventilating treatment on lobed forced mixer with a big lobed angle is able to eliminate the separation bubble inside the nozzle.(3)The same treatment on the other hand does not banish the separation bubble inside the lobed ejector mixer with a big lobed angle. In fact

the ventilating gap brings forward the separation phenomena rather than avoiding it.

关键词

Keywords

references

Views

1105

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical simulation of the aerodynamics performance of swept and curved blade on the compressor stator

Preliminary aerodynamic exploration for bioinspired separated flow airfoil at low Reynolds number

Simulation method of short crack propagation in turbine disks based on crystal plasticity

Design of dual⁃bell nozzles with different extension pressure distributions

Coupling model of self⁃ and external⁃excitation for phenomena in pulsed jet flow control

Related Author

FENG Xiu-lian

JIN Dong-hai

GUI Xing-min

Qing ZHANG

Rongrong XUE

Haotong MA

Ping ZHANG

Shan LU

Related Institution

School of Jet Propulsion, Beijing University of Aeronautics and Astronautics

School of Aircraft，Xi'an Aeronautical University

School of Mechanical and Aerospace Engineering，Nanyang Technological University

Institute of Optics and Electronics，Chinese Academy of Sciences

Key Laboratory of Optical Engineering，Chinese Academy of Sciences

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰