Optical measurement and characteristic analysis of aeroengine combustor primary zone with counter-rotating swirler

CHEN Min; SONG Wen-yan; XIAO Yin-li; CHEN Liang; LI Jian-ping

Chinese

您当前的位置：

首页 >

文章列表页 >

Optical measurement and characteristic analysis of aeroengine combustor primary zone with counter-rotating swirler

更新时间：2026-07-07

- Optical measurement and characteristic analysis of aeroengine combustor primary zone with counter-rotating swirler
- Vol. 28, Issue 8, (2013)
- 作者机构：
  
  西北工业大学动力与能源学院,西安,710072
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2013
- 稿件说明：
移动端阅览
CHEN Min, SONG Wen-yan, XIAO Yin-li, et al. Optical measurement and characteristic analysis of aeroengine combustor primary zone with counter-rotating swirler[J]. 2013, 28(8).
DOI：

CHEN Min, SONG Wen-yan, XIAO Yin-li, et al. Optical measurement and characteristic analysis of aeroengine combustor primary zone with counter-rotating swirler[J]. 2013, 28(8). DOI：

摘要

针对斜切径向旋流环形燃烧室模型

采用可调谐二极管激光吸收光谱(TDLAS)、相干反斯托克斯喇曼光谱(CARS)光学测量手段

在模化状态(Case 2)下

对燃烧室主燃区进行温度测量

分别得到了主燃区内12个点的温度和沿两条路径的积分温度.使用Fluent 12.0对Case 2进行数值模拟

分别使用两种非预混燃烧模型:平衡化学反应模型(EM)和稳态层流小火焰(SLF)模型.通过将两种不同燃烧模型的计算结果与TDLAS

CARS试验测量数据作对比验证

发现EM计算得到的温度更高

并与试验测量温度更符合

其中与CARS测量的误差小于6%.在试验验证的基础上

完成燃烧室在冷流状态(Case 1)下的计算

分析主燃区的气流组织和主燃孔射流对回流区的影响;利用EM计算分析燃烧室主燃区在全压状态(Case 3)下燃料分布、温度场、组分分布和性能参数

如燃烧室的燃烧效率为0.97、出口温度分布系数为0.312等

较为全面反映了燃烧室内气流流动换热和燃烧现象.

Abstract

For an aeroengine annular combustor model

coherent anti-Stokes Raman scattering (CARS) and tunable diode laser absorption spectroscopy (TDLAS) were used to measure temperature in primary zone (PZ) for modeling condition(Case 2).Based on Fluent 12.0 software

two different non-premixed combustion models equilibrium model (EM) and steady laminar flamelet (SLF) model were adopted to calculate the combustor performances for the same case.Then comparison between spectral measured temperature and numerical simulated one shows that higher and more accurate prediction were achieved by EM.What's more

the errors between EM calculation and CARS measurement are less than 6%.For cold flow condition(Case 1)

not only detailed analysis of flow field in PZ was made

but also the influence of primary jet on recirculation zone was investigated.Because of the advantage EM was used for full pressure condition (Case 3) to analyze reaction flow field in PZ and calculate combustor performances

including combustion efficiency(0.97)

overall temperature distribution factor (OTDF)(0.312)

etc.These results indicate reasonable heat transfer and combustion phenomena in combustor model.

关键词

Keywords

references

Views

1150

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Analysis on swirl cup combustor near lean blow out point with flamelet model

与发动机匹配的旁路式双喉道气动矢量喷管数值模拟研究

基于三维接触摩擦单元的套齿连接解析建模研究

基于自适应MOMEDA滚动轴承故障特征提取方法

考虑多源不确定性的复合材料风扇叶片高周疲劳失效概率评估

Related Author

CAO Wen-Yu

YUAN Yi-xiang

XIE Peng-fu

YU Chao

CHEN Cong

ZHAN De-jun

TAN Chun-qing

Related Institution

Institute of Engineering Thermophysics, Chinese Academy of Sciences

School of Physics, University of Chinese Academy of Sciences

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰