Flexural stiffness calculation method for reinforced gradient concrete beams consisting of normal and high strength concrete
|更新时间:2026-10-19
|
Flexural stiffness calculation method for reinforced gradient concrete beams consisting of normal and high strength concrete
Vol. 43, Issue 12, Pages: 30-35(2011)
作者机构:
哈尔滨工业大学 土木工程学院,150090 哈尔滨,zhouwei-hit@163.com
作者简介:
基金信息:
DOI:
CLC:TU375.1
Published:2011
稿件说明:
移动端阅览
ZHOU Wei, ZHENG Wen-zhong. Flexural stiffness calculation method for reinforced gradient concrete beams consisting of normal and high strength concrete[J]. 2011, 43(12): 30-35.
DOI:
ZHOU Wei, ZHENG Wen-zhong. Flexural stiffness calculation method for reinforced gradient concrete beams consisting of normal and high strength concrete[J]. 2011, 43(12): 30-35.DOI:
Flexural stiffness calculation method for reinforced gradient concrete beams consisting of normal and high strength concrete
The reinforced gradient concrete beams consist of normal and high strength concrete
in which the compressed zone is made of high strength concrete
and the tensile one is made of normal strength concrete. Experiment on these simply supported beams with two-point loading was carried out
and the test results of strains and deflections of the beams under short-term load were verified and compared with those of nonlinear analysis. It revealed that the average strain at the outer fiber in the compressive zone increased linearly with the increase of external loading. Thus
the general coefficient of average compressive strain at the outer fiber was introduced
and its calculated equation was proposed. Based on the analysis of crack development and curvature of cross section
the calculation method on the immediate and long-term stiffness was proposed for the reinforced gradient concrete flexural member with rectangle section.