Experiment on axial-compressor stability enhancement by blade tip injection

SHI Pei-jie; QIAO Wei-yang; WANG Liang-feng; CHEN Wei-jie; XU Kun-bo

doi:10.13224/j.cnki.jasp.2014.02.018

Chinese

您当前的位置：

首页 >

文章列表页 >

Experiment on axial-compressor stability enhancement by blade tip injection

更新时间：2026-07-07

- Experiment on axial-compressor stability enhancement by blade tip injection
- Vol. 29, Issue 2, Pages: 384-390(2014)
- 作者机构：
  
  西北工业大学动力与能源学院,西安,710072
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2014.02.018
  CLC：
- Published：2014
- 稿件说明：
移动端阅览
时培杰, 乔渭阳, 王良锋, 陈伟杰, 许坤波. 轴流压气机叶尖射流扩稳试验[J]. 航空动力学报, 2014, 29(2): 384-390.

doi: 10.13224/j.cnki.jasp.2014.02.018
时培杰, 乔渭阳, 王良锋, 陈伟杰, 许坤波. 轴流压气机叶尖射流扩稳试验[J]. 航空动力学报, 2014, 29(2): 384-390. DOI： 10.13224/j.cnki.jasp.2014.02.018.

doi: 10.13224/j.cnki.jasp.2014.02.018 DOI：

摘要

采用转子叶尖射流对轴流压气机进行了扩稳试验研究.试验中对无射流的轴流压气机失速起始类型进行了测量，发现该轴流压气机以尖峰波的形式进入旋转失速；之后采用叶尖射流发现射流对压气机的失速起始过程没有明显影响.试验中对射流孔数目、射流孔周向分布和射流偏转角3个参数对压气机扩稳效果的影响进行了分析.测量结果发现：保持总射流流量不变，增加射流孔数目会降低轴流压气机扩稳效果；而在单个射流孔流量不变的情况下，增加射流孔数目会增大扩稳效果；射流孔周向分布越均匀扩稳效果越明显；射流扩稳效果与转子相对坐标系下的气动参数有直接关系，故采用相对坐标系下射流零攻角方向的动量分量与主流动量比值对扩稳效果进行了关联.

Abstract

Experimental study of blade tip injection effects on the stability of a axial-compressor was carried out. The rotating stall signal was verified and spike type stall inception was detected when there was no injection

and it was found that the type of the stall inception signal did not change after tip injection was used. The effects of the number of tip injectors

circumferential distribution of injectors and yaw angle of injector on the effectiveness of stability enhancement were measured and analyzed. From the experimental results

it can be concluded that the stability was enhanced by either decreasing the number of injectors while keeping the total mass flow of injectors constant

or by increasing the number of injectors under the condition that the mass flow of a single injector keeps constant

and the stability was decreased by increasing the unevenness of injectors. It was also found that effectiveness of stability enhancement by tip injection was related to the parameters of injection flow in the relative frame of rotor. The association relation between the momentum component of the injection flow along the flow direction of zero incidence angle in the relative coordinate

which is scaled by the momentum of main flow

and effectiveness of stability enhancement was built.

关键词

Keywords

references

Views

935

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Model description of rotating stall boundary in low-speed axial compressor

Effects of rotating disturbance on aerodynamics stability of axial-flow compressor

Numerical simulation on stall margin improvement of transonic compressor by a trapped vortex casing treatment

Experiment on single axial compressor of characteristic of rotating stall

Identification of stall characteristics of axial flow compressor

Related Author

李志平

张鹏

李秋实

MAO Zhi-ming

HU Jun

ZHANG Huan

YAN Wei

WANG Zhuo-qi

Related Institution

北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室

先进航空发动机协同创新中心

Jiangsu Province Key Laboratory of Aerospace Power System, College of Energy and Power Engineering, Nanjing University of Aeronautics and Astronautics

Research Institute of Unmanned Aerial Vehicle, Beijing University of Aeronautics and Astronautics

National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics,School of Energy and Power Engineering,Beijing University of Aeronautics and Astronautics

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰