Numerical simulation of friction torque of rotating disc for rotor-stator system with central inflow

ZHANG Da; HAN Jian-qiao; LUO Xiang; XU Guo-qiang

doi:10.13224/j.cnki.jasp.2014.04.003

Chinese

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of friction torque of rotating disc for rotor-stator system with central inflow

更新时间：2026-07-07

- Numerical simulation of friction torque of rotating disc for rotor-stator system with central inflow
- Vol. 29, Issue 4, Pages: 755-762(2014)
- 作者机构：
  
  北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室,北京,100191
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2014.04.003
  CLC：
- Published：2014
- 稿件说明：
移动端阅览
张达, 韩建桥, 罗翔, 徐国强. 中心进气转静系转盘风阻扭矩数值模拟[J]. 航空动力学报, 2014, 29(4): 755-762.

doi: 10.13224/j.cnki.jasp.2014.04.003
张达, 韩建桥, 罗翔, 徐国强. 中心进气转静系转盘风阻扭矩数值模拟[J]. 航空动力学报, 2014, 29(4): 755-762. DOI： 10.13224/j.cnki.jasp.2014.04.003.

doi: 10.13224/j.cnki.jasp.2014.04.003 DOI：

摘要

采用计算流体力学(CFD)商业软件CFX从流动参数及几何结构两个方面对中心进气转静系盘腔内转盘风阻扭矩特性进行了数值模拟研究

同时搭建一个转盘风阻扭矩实验台测量自由盘风阻扭矩.中心进气转静系转盘风阻扭矩与经典经验公式进行了对比

结果表明:利用数值模拟方法

得到的无量纲扭矩系数与经典经验关系式计算得到的数据总体相差小于10%

利用湍流参数来表征转盘转速以及叠加流流量

对于分析转盘风阻扭矩非常便利.利用湍流参数定量分析时需注意叠加流以及转速的量级同样影响着风阻扭矩的数值.几何结构对于风阻扭矩也有影响

但相比流动参数影响较小.

Abstract

In order to investigate the friction torque performance of rotating disc for rotor-stator system with central inflow

numerical simulation was conducted by using computational fluid dynamic (CFD) commercial software CFX in consideration of flow parameters and geometric structure respectively. A test rig for the friction torque of rotating disc was developed to test the friction torque of free disc. The numerical simulation results were compared with the previous empirical associated correlation for the friction torque of rotating disc for rotor-stator system with central inflow. The results show that compared with the previous empirical associated correlation

the difference of dimensionless the moment coefficient is within 10%. It is convenient to use turbulent parameter which represents the rotating speed and superimposed flow to analyze the friction torque of the rotating disc. For a given value of the turbulence parameter

the magnitudes of the rotating speed and superimposed flow have effect on the friction torque. Compared with the flow parameters

geometric parameters have smaller influence on friction torque.

关键词

Keywords

references

Views

1066

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Windage heating experiment on rotating disc in cavity of rotor-stator system

Application of θ projection method in analysis of creep deformation of turbine disc

Numerical study on characteristics of temperature reduction and flow loss in radial pre-swirl system

Experiment of flow characteristics of direct transfer pre-swirl system

Experiment of turbine disc low cycle fatigue life with additional torque

Related Author

LUO Xiang

ZHANG Da

高靖云

王延荣

李昆

陈妍妍

魏大盛

WANG Suo-fang

Related Institution

北京航空航天大学能源与动力工程学院

中国航空发动机集团有限公司商用航空发动机有限责任公司上海商用飞机发动机工程技术研究中心

College of Energy and Power Engineering,Nanjing University of Aeronautics and Astronautics

National Key Laboratory of Science and Technology on Aero-Engine Aero-thermodynamics,School of Jet Propulsion, Beijing University of Aeronautics and Astronautics

School of Jet Propulsion, Beijing University of Aeronautics and Astronautics

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰