Air bridge technology for engine power simulation test in wind tunnel

ZHANG Rong-ping; WANG Xun-nian; HUANG Yong

doi:10.13224/j.cnki.jasp.2015.04.018

Chinese

您当前的位置：

首页 >

文章列表页 >

Air bridge technology for engine power simulation test in wind tunnel

更新时间：2026-07-07

- Air bridge technology for engine power simulation test in wind tunnel
- Vol. 30, Issue 4, Pages: 910-915(2015)
- 作者机构：
  
  1. 中国空气动力研究与发展中心空气动力学国家重点实验室,四川,绵阳,621000
  2. 中国空气动力研究与发展中心低速空气动力学研究所,四川,绵阳,621000
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2015.04.018
  CLC：
- Published：2015
- 稿件说明：
移动端阅览
章荣平, 王勋年, 黄勇. 发动机动力模拟风洞试验中的空气桥技术[J]. 航空动力学报, 2015, 30(4): 910-915.

doi: 10.13224/j.cnki.jasp.2015.04.018
章荣平, 王勋年, 黄勇. 发动机动力模拟风洞试验中的空气桥技术[J]. 航空动力学报, 2015, 30(4): 910-915. DOI： 10.13224/j.cnki.jasp.2015.04.018.

doi: 10.13224/j.cnki.jasp.2015.04.018 DOI：

摘要

介绍了发动机动力模拟风洞试验中的空气桥设计技术和影响修正方法.通过自由度分析

选择了合理空气桥布局

采用有限元方法对空气桥关键受力梁进行了优化

建立了空气桥天平一体化数值模拟技术

使得空气桥和天平刚度更加匹配.通过这些设计及优化使得空气桥的作用力最小

并具有较强的克服压力影响、温度影响的能力.通过试验建立了空气桥附加刚度影响、内部压力影响、温度影响和内部流量影响的修正方法

进一步减小了空气桥对天平的影响.在8m×6m低速风洞进行了某大展弦比飞机全模涡扇动力模拟器(TPS)短舱动力模拟试验.试验结果重复性好

阻力系数精度达到0.0003

和相关文献吻合.这表明空气桥技术是成功的

满足了TPS短舱动力模拟试验要求.

Abstract

The design technology and correction method of the air bridge for engine simulation test in wind tunnel were presented. The layout of the air bridge was determined according to freedom analysis. By finite element analysis

the key beams of air bridge were optimized. The rigidity of the air bridge and the balance was matched based on air bridge and balance assembly numerical simulation. These design and optimization minimized the applied force of the air bridge and improved the capacity for overcoming pressure and temperature effect. The rigidity effect

pressure effect

temperature effect and mass flow effect of the air bridge were corrected by serial tests. These corrections further minimized residual force of the air bridge. A high aspect ratio airplane full-span turbofan powered simulators (TPS) test was conducted in 8 m×6 m low speed wind tunnel .The test results were good in repeatability. The standard deviation of drag coefficient was 0.0003. The test results also agreed well with related papers. The air bridge technology is thus proved successful and can meet the requirement of TPS nacelle power simulation test.

关键词

Keywords

references

Views

900

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Design and test of short centerline probe in continuous transonic wind tunnel

Integrated jet-effects testing technique based on calibration tank in low-speed wind tunnel

Design and test verification of small loitering munition electric-powered propulsion system

Improved dissipative model of hydrodynamic in tube

Design and optimization of columniform distributed ejector for low speed wind tunnel inlet test

Related Author

Haijun DENG

Bo XIONG

Xinfu LUO

Shaozun HONG

Tengji LI

Libo ZHANG

Xinfeng HAN

HU Buyuan

Related Institution

High Speed Aerodynamics Institute，China Aerodynamics Research and Development Center

Low Speed Aerodynamics Institute,China Aerodynamics Research and Development Center

中国空气动力研究与发展中心低速空气动力研究所

中国空气动力研究与发展中心空气动力学国家重点实验室

中国航空发动机集团有限公司商用航空发动机有限责任公司

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰