Influence of contact characteristics on thermal induced vibration of non-continuous rotor

XU Ning; LIU Zhan-sheng; DONG Yan-yang; WANG Zhen-lin; WANG Qing-chao

doi:10.13224/j.cnki.jasp.2015.07.013

Chinese

您当前的位置：

首页 >

文章列表页 >

Influence of contact characteristics on thermal induced vibration of non-continuous rotor

更新时间：2026-07-07

- Influence of contact characteristics on thermal induced vibration of non-continuous rotor
- Vol. 30, Issue 7, Pages: 1624-1631(2015)
- 作者机构：
  
  1. 哈尔滨工业大学能源科学与工程学院,哈尔滨,150001
  2. 中国船舶重工集团公司第七〇三研究所,哈尔滨,150078
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2015.07.013
  CLC：
- Published：2015
- 稿件说明：
移动端阅览
徐宁, 刘占生, 董延阳, 王震林, 王庆超. 接触特性对非连续性转子热致振动的影响[J]. 航空动力学报, 2015, 30(7): 1624-1631.

doi: 10.13224/j.cnki.jasp.2015.07.013
徐宁, 刘占生, 董延阳, 王震林, 王庆超. 接触特性对非连续性转子热致振动的影响[J]. 航空动力学报, 2015, 30(7): 1624-1631. DOI： 10.13224/j.cnki.jasp.2015.07.013.

doi: 10.13224/j.cnki.jasp.2015.07.013 DOI：

摘要

针对燃气轮机转子的非连续性结构间存在的接触特性

根据微凸体理论引入接触刚度和接触热阻的等效模型

建立了某型燃气轮机非连续性转子的动力学模型

分析了接触参数对转子稳、瞬态动力学特性的影响

研究了螺栓松动引起的转子热变形及其对转子快速启动过程中振动特性的影响.结果表明:预紧力、接触面的表面粗糙度和螺栓个数对转子临界转速有一定的影响

螺栓松动导致转子在启动过程中瞬态热变形最大达到7μm

过1阶临界转速时引起的转子最大响应幅值增大约30μm.在非连续性转子系统的热致振动特性分析当中

不应忽视接触参数、接触刚度和接触热阻的影响.

Abstract

According to the contact characteristics of the non-continuous structure in gas turbine rotor and the asperity theory

the contact stiffness and contact thermal resistance equivalent model were introduced. Dynamic model for a non-continuous rotor of gas turbine was established. The influence of contact parameters on steady and transient state dynamic characteristic of rotor was analyzed.The thermal deformation of rotor caused by bolt looseness was studied

and the vibration characteristics of rotor based on fast start-up process were analyzed. Result shows that

the pre-tightening force

surface roughness of contact surface and bolt number have a certain influence on critical speeds of rotor

the maximum transient thermal deformation of rotor caused by bolt looseness in start-up process is up to 7μm

and the maximum response amplitude caused by rotor across the first critical speed is increased about 30μm. The influence of contact parameters

contact stiffness and contact thermal resistance of non-continuous rotor on thermally induced vibration characteristics analyze should not be ignored.

关键词

Keywords

references

Views

628

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental investigation on contact thermal resistance characteristics of aero⁃engine flange

Modeling and application test of contact stiffness of bolt connection structure of disk and drum

Effects of mutational load on performanceof gas turbine generator set

Thermodynamic cycle performance of detonation gas turbine with variable specific heat capacity

与发动机匹配的旁路式双喉道气动矢量喷管数值模拟研究

Related Author

Yan CHEN

Guangya FAN

Zhihui LIN

Bowen SHI

Gaowen LIU

Guang ZHAO

Yongquan WANG

Xiangyang ZHAO

Related Institution

School of Power and Energy，Northwestern Polytechnical University

Shaanxi Key Laboratory of Thermal Science in Aero⁃engine System，Northwestern Polytechnical University

Commercial Aircraft Engine Company Limited，Aero Engine Corporation of China

Sichuan Gas Turbine Establishment，Aero Engine Corporation of China

School of Energy and Power Engineering，Dalian University of Technology

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰