Influence of exterior hot-film on droplet impingement characteristics over aero-engine inlet strut

柯鹏; 张韵; 于广锋; 杨春信

doi:10.13224/j.cnki.jasp.2017.03.014

Chinese

您当前的位置：

首页 >

文章列表页 >

Influence of exterior hot-film on droplet impingement characteristics over aero-engine inlet strut

更新时间：2026-07-07

- Influence of exterior hot-film on droplet impingement characteristics over aero-engine inlet strut
- Vol. 32, Issue 3, Pages: 621-629(2017)
- 作者机构：
  
  1. 北京航空航天大学交通科学与工程学院,北京,100191
  2. 北京航空航天大学航空科学与工程学院,北京,100191
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2017.03.014
  CLC：
- Published：2017
- 稿件说明：
移动端阅览
柯鹏, 张韵, 于广锋, 杨春信. 航空发动机进口支板外部热气膜对水滴撞击特性的影响[J]. 航空动力学报, 2017, 32(3): 621-629.

doi: 10.13224/j.cnki.jasp.2017.03.014
柯鹏, 张韵, 于广锋, 杨春信. 航空发动机进口支板外部热气膜对水滴撞击特性的影响[J]. 航空动力学报, 2017, 32(3): 621-629. DOI： 10.13224/j.cnki.jasp.2017.03.014.

doi: 10.13224/j.cnki.jasp.2017.03.014 DOI：

摘要

设计了4种不同气膜缝角度的防护结构，发展并验证了基于欧拉法框架的水滴撞击算法，针对直径为20μm的过冷小水滴，定量分析了气膜缝角度和吹风比对支板壁面水滴撞击特性的影响规律.研究结果表明，外部热气膜射流对水滴有明显吹袭作用，导致壁面平均局部水收集系数和撞击极限减小，而且气膜缝开孔位置越靠近支板前缘，吹袭水滴效果越明显.4种结构的平均局部水收集系数与无气膜缝结构相比分别下降了82%，8%，1%和0.5%.此外，吹风比增大会导致前缘最大局部水收集系数和撞击极限的减小变明显，尤其是气膜缝角度为5°结构的水滴撞击特性受吹风比影响最显著.前缘区域局部水收集系数呈现了相似的分布规律；支板后部区域，当吹风比增大到一定程度时，水滴被完全吹除.

Abstract

Four ice-protection structures with different film-slot angles were designed

an Eulerian-framework based droplet impingement computation method was developed and verified to study the influences of film-slot angle and blowing ratio on droplet impingement characteristics for 20μm diameter. The results indicated that the exterior hot-film can blow the droplet away to decrease local collection efficiency and impingement limitation significantly

and the influence was more evident when the position of film-slot was closer to strut leading edge

the average local collection efficiencies of four structures declined 82%

1% and 0.5%

respectively

compared with no-film situation. Besides

the maximum local collection efficiency and impingement limitation decreased with the increasing blowing ratio. The impingement characteristics of film-slot angle 5°was most sensitive to blowing ratio. Similar local collection efficiency distribution features were presented at leading edge. For rear area

when blowing ratio was big enough

no droplet impinged on the surface.

关键词

Keywords

references

Views

425

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Phase transition characteristics of ice crystal particles in motion

Numerical investigation of thermal and mechanical equilibrium characteristics of ice crystal in large icing wind tunnel

Icing wind tunnel test evaluation on anti-icing effects of hydrophobic coating on two parallelized square cylinders

Heating characteristics of aero-engine nose cone with film-heating anti-icing systemA

Numerical simulation of runback film breakup on two-dimensional anti-icing airfoil surface

Related Author

Ping HUANG

Xueqin BU

Guiping LIN

Jia YU

Zhanwei HU

Liang DING

Xian YI

Pingtao ZHANG

Related Institution

School of Aeronautic Science and Engineering，Beihang University

Key Laboratory of Icing and Anti/De⁃icing， China Aerodynamics Research and Development Center

中国空气动力研究与发展中心空气动力学国家重点实验室

中国空气动力研究与发展中心飞行器结冰与防除冰重点实验室

北京航空航天大学交通科学与工程学院飞机/发动机综合系统安全性北京市重点实验室

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰