Numerical simulation of effect of turbulence flow in nozzle on flame lift-off length

齐文亮; 明平剑; 张文平; 王文辉

doi:10.13224/j.cnki.jasp.2018.12.006

Chinese

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of effect of turbulence flow in nozzle on flame lift-off length

更新时间：2026-07-07

- Numerical simulation of effect of turbulence flow in nozzle on flame lift-off length
- Vol. 33, Issue 12, (2018)
- 作者机构：
  
  哈尔滨工程大学动力与能源工程学院,哈尔滨,150001
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2018.12.006
  CLC：
- Published：2018
- 稿件说明：
移动端阅览
齐文亮, 明平剑, 张文平, 王文辉. 喷嘴内湍流运动对火焰浮起长度影响的数值模拟[J]. 航空动力学报, 2018, 33(12). doi: 10.13224/j.cnki.jasp.2018.12.006

齐文亮, 明平剑, 张文平, et al. Numerical simulation of effect of turbulence flow in nozzle on flame lift-off length[J]. 2018, 33(12).
齐文亮, 明平剑, 张文平, 王文辉. 喷嘴内湍流运动对火焰浮起长度影响的数值模拟[J]. 航空动力学报, 2018, 33(12). doi: 10.13224/j.cnki.jasp.2018.12.006 DOI：

齐文亮, 明平剑, 张文平, et al. Numerical simulation of effect of turbulence flow in nozzle on flame lift-off length[J]. 2018, 33(12). DOI： 10.13224/j.cnki.jasp.2018.12.006.

摘要

为考虑喷嘴内部湍流运动对燃油雾化和火焰浮起长度的影响

将喷嘴内部的湍流流动以权重的形式加入初次破碎模型中

并对二次破碎模型进行了修正。建立了完整的燃油雾化和燃烧的数学模型。通过与实验数据对比来验证燃油雾化模型的准确性

并讨论了喷嘴内湍流运动对燃油雾化过程的影响。结果表明

湍流运动会加快液滴破碎和蒸发的速率

从而减小燃油蒸气贯穿距。火焰浮起长度的计算采用本文建立的燃油雾化模型

成功计算了火焰浮起长度随氧气体积分数、气体密度、气体温度和入射压力变化的规律。同时发现在不同气体密度和氧气体积分数的工况下

喷嘴内部湍流运动对火焰浮起长度的影响基本保持不变

分别为9%和13%；入射压力和气体温度的升高会导致喷嘴内部湍流对火焰浮起长度的影响逐渐变大。

Abstract

In order to consider the effect of turbulence inside the nozzle on fuel spray and flame lift-off length

the turbulence was characterized by the length scale and time scale and added into primary breakup model in the form of weight coefficient

and the secondary breakup process was modified. A mathematical model of fuel spray and combustion was established. The mathematical model was validated by experimental data

and the effect of turbulence term on fuel spray was analyzed. Results indicated that the turbulence term can accelerate the rate of droplet breakup and evaporation

decrease the fuel vapor penetration. The calculation of the flame lift length was based on the fuel atomization model. These models can well predict the flame lift-off length at different conditions of oxygen volume fraction

ambient density

ambient temperature and injection pressure. It also can be found that the effect of turbulence inside the nozzle on flame lift-off length was 9% and 13% at different ambient density and oxygen volume fraction conditions

and the injection pressure and ambient temperature could enhance the influence of turbulence inside nozzle on flame lift-off length.

关键词

Keywords

references

Views

594

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Evaluation of different breakup models and application to the mixture preparation process for diesel engines

Experimental investigations on breakup characteristic of single droplet in the core/bag breakup regime inthe continuous uniform heating airflow

Experiment on impact of initial diameter on breakup characteristic of single droplet

Numerical study of influences of primary jets on turbulent flows and spray combustion in model combustor

CFD Simulation and Validation of Ducted Tail Rotor

Related Author

彭晔

王锁芳

刘勇

金仁瀚

LIU Yong

WANG Suo-fang

FENG Zhi-peng

ZHU Dong-qing

Related Institution

盐城工学院汽车工程学院

南京航空航天大学能源与动力学院江苏省航空动力系统重点实验室

Jiangsu Province Key Laboratory of Aerospace Power System, College of Energy and Power Engineering, Nanjing University of Aeronautics and Astronautics

School of Aeronautical Science and Engineering, Beijing University of Aeronautics and Astronautics

Dept.Energy and Power Engineering,Xi'an Jiaotong University

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰