Effect of impeller velocity coefficient on parameters ratios between pump and its reverse mode

王晓晖; 杨军虎; 夏正廷; 苗森春; 史凤霞

doi:10.13224/j.cnki.jasp.2019.02.026

Chinese

您当前的位置：

首页 >

文章列表页 >

Effect of impeller velocity coefficient on parameters ratios between pump and its reverse mode

更新时间：2026-07-07

- Effect of impeller velocity coefficient on parameters ratios between pump and its reverse mode
- Vol. 34, Issue 2, (2019)
- 作者机构：
  
  兰州理工大学能源与动力工程学院,兰州,730050
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2019.02.026
  CLC：
- Published：2019
- 稿件说明：
移动端阅览
王晓晖, 杨军虎, 夏正廷, 苗森春, 史凤霞. 叶轮流速系数对泵正反转性能参数比的影响[J]. 航空动力学报, 2019, 34(2). doi: 10.13224/j.cnki.jasp.2019.02.026

王晓晖, 杨军虎, 夏正廷, et al. Effect of impeller velocity coefficient on parameters ratios between pump and its reverse mode[J]. 2019, 34(2).
王晓晖, 杨军虎, 夏正廷, 苗森春, 史凤霞. 叶轮流速系数对泵正反转性能参数比的影响[J]. 航空动力学报, 2019, 34(2). doi: 10.13224/j.cnki.jasp.2019.02.026 DOI：

王晓晖, 杨军虎, 夏正廷, et al. Effect of impeller velocity coefficient on parameters ratios between pump and its reverse mode[J]. 2019, 34(2). DOI： 10.13224/j.cnki.jasp.2019.02.026.

摘要

为研究叶轮流速系数对离心泵反转作液力透平(PAT)泵工况和透平工况水力性能参数比的影响，采用renormalization group(RNG) k-ε湍流模型，通过计算流体动力学软件CFX计算了比转速为23~225的20个PAT叶轮单流道模型的流速系数，揭示了泵工况和透平工况流速系数的分布规律，建立了考虑流速系数的PAT泵工况与透平工况扬程比和流量比。结果表明：PAT透平工况叶轮流速系数大于泵工况。通过对不同比转速的6台工业PAT的外特性实验表明：与Stepanoff等提出的方法相比，考虑流速系数时PAT水力性能参数比与实验结果最为接近，其扬程比平均误差为5.38%，流量比平均误差为5.16%。该成果为PAT的选型设计和性能预测提供理论支撑。

Abstract

In order to study the head ratio and flow rate ratio between pump and turbine mode of pump as turbine (PAT) based on the impeller velocity coefficient

20 single passage impellers with specific speed 23-225 were analyzed based on renormalization group (RNG) k-ε simulation by CFX. The distribution of velocity coefficient was revealed for pump mode and turbine mode

and new head ratio and flow rate ratio between pump and turbine mode based on impeller velocity coefficient were proposed. Results showed that the impeller velocity coefficient of turbine mode was higher than the pump mode. Then 6 industrial PATs were experimented in experiment rig

indicating the result by the this method had less error than the results of Stepanoff

et al. The average errors of head ratio and flow rate ratio were just 5.38% and 5.16%

respectively. The study provides a theoretical basis for the selection and performance prediction of PAT.

关键词

Keywords

references

Views

375

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Influence of the U-shape inlet pipe on a centrifugal compressor performance

Phase space reconstruction and fractal characteristic of rotating stall in impeller of centrifugal compressor

Experimental study on flow in the impeller of low specific speed pump using particle image velocimetry

Multi-objective optimization of centrifugal pump impeller for conceptual design

Numerical Simulation of Two-Phase Flow in Impeller

Related Author

YANG Ce

LIU Heng

ZHAO Ben

LAO Da-zhong

WANG Lei-lei

TIAN Mei

ZHOU Cheng-wu

ZHANG Jia-zhong

Related Institution

Turbomachinery Institute, School of Mechanical Engineering, Beijing Institute of Technology

Mechanical and Electrical Engineering Institute, Hebei University of Engineering

School of Energy and Power Engineering, Xi'an Jiaotong University

College of Mechanical and Power Engineering, Nanjing University of Technology

School of Astronautics, Beijing University of Aeronautics and Astronautics

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰