Adaptive wavelet threshold function based on PSO-RWE ,for vibration signal denoising of rolling bearing

YANG Xu; QIU Ming; CHEN Lihai

doi:10.13224/j.cnki.jasp.2020.11.010

Chinese

您当前的位置：

首页 >

文章列表页 >

Adaptive wavelet threshold function based on PSO-RWE ,for vibration signal denoising of rolling bearing

更新时间：2026-07-07

- Adaptive wavelet threshold function based on PSO-RWE ,for vibration signal denoising of rolling bearing
- Vol. 35, Issue 11, Pages: 2339-2347(2020)
- 作者机构：
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.2020.11.010
  CLC：
- Published：2020
- 稿件说明：
移动端阅览
杨旭, 邱明, 陈立海. 基于PSO-RWE的自适应小波阈值函数滚动轴承振动信号去噪方法[J]. 航空动力学报, 2020, 35(11): 2339-2347.

doi: 10.13224/j.cnki.jasp.2020.11.010
杨旭, 邱明, 陈立海. 基于PSO-RWE的自适应小波阈值函数滚动轴承振动信号去噪方法[J]. 航空动力学报, 2020, 35(11): 2339-2347. DOI： 10.13224/j.cnki.jasp.2020.11.010.

doi: 10.13224/j.cnki.jasp.2020.11.010 DOI：

摘要

针对现有小波去噪方法存在阈值函数中未知参数选取依赖经验

导致去噪不充分或去噪后信号失真的问题。提出了一种基于相对小波熵(RWE)的粒子群优化(PSO)算法

用于小波阈值函数中未知参数的自适应寻优

达到滚动轴承振动信号自适应降噪目的。改进了一种含两未知参数的小波阈值函数;以相对小波熵为优化算法的适应度函数对未知参数进行自适应寻优

得到最优小波阈值函数;通过对模拟仿真信号和试验采集的滚动轴承振动信号进行分析。结果表明:优化后的小波去噪方法能够更好地将噪声从染噪信号中滤除

去噪后信号波形的平滑度更好

信噪比相较硬阈值去噪提高294%

而且保留了原始信号更多的细节特征

具有更好的去噪性能和应用实用价值。

Abstract

In view of the existing wavelet threshold denoising method that unknown parameters selection in existing functions depends on experience and brings about insufficient denoising or signal distortion after denoising

a particle swarm optimization (PSO) algorithm based on relative wavelet entropy (RWE) was proposed for adaptive optimization of unknown parameters in wavelet threshold function to achieve adaptive noise reduction of rolling bearing vibration signal. A wavelet threshold function with two unknown parameters was improved. The relative wavelet entropy was used as the fitness function to optimize the unknown parameters and the optimal wavelet threshold function was obtained. The vibration signal of rolling bearing acquired by simulation and experiment was analyzed. Results showed that the optimized wavelet denoising method can filter the noise from the denoised signal better

the signal waveform after denoising had better smoothness

the signal-to-noise ratio was 294% higher than the hard threshold

and retained more details of the original signal

presenting better denoising performance and practical value.

关键词

Keywords

references

Views

195

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Resonance demodulation technique based on IHT for rolling bearings fault diagnosis

Wear life analysis of angular contact ball bearing in high temperature environment

Grey relation analysis on nonlinear characteristics and uncertainty characteristics of evolution of rolling bearing vibration performance state

Fault diagnosis of rolling bearings based on IRCMNDE and NNCHC

Residual life prediction of rolling bearing under multiple stresses

Related Author

DENG Si-er

WANG Yong

WANG Heng-di

Rongjun NIU

Zhengjie HAN

Yufei WANG

Hongliang LI

Sier DENG

Related Institution

School of Mechatronics Engineering,Henan University of Science and Technology

School of Mechatronics Engineering， Henan University of Science and Technology

Special Bearing Business Department， Luoyang Bearing Research Institute Company，Limited

Collaborative Innovation Center of Major Machine Manufacturing in Liaoning

National United Engineering Laboratory for Advanced Bearing Tribology， Henan University of Science and Technology

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰