Experiment on discharge coefficients for outlet lateral dilated hole

Buming WAN; Jun CAO; Chaochao LI; Jiang CHEN

doi:10.13224/j.cnki.jasp.20200548

Chinese

您当前的位置：

首页 >

文章列表页 >

Experiment on discharge coefficients for outlet lateral dilated hole

Combustion, Heat and Mass Transfer | 更新时间：2025-04-07

- Experiment on discharge coefficients for outlet lateral dilated hole
- Journal of Aerospace Power Vol. 36, Issue 11, Pages: 2325-2330(2021)
- 作者机构：
  
  中国航空发动机集团有限公司湖南动力机械研究所，湖南株洲 412002
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.20200548
  CLC：
- 稿件说明：
移动端阅览
Buming WAN, Jun CAO, Chaochao LI, et al. Experiment on discharge coefficients for outlet lateral dilated hole[J]. Journal of Aerospace Power, 2021, 36(11): 2325-2330.
DOI：

Buming WAN, Jun CAO, Chaochao LI, et al. Experiment on discharge coefficients for outlet lateral dilated hole[J]. Journal of Aerospace Power, 2021, 36(11): 2325-2330. DOI： 10.13224/j.cnki.jasp.20200548.

摘要

采用试验研究的方法，探讨了不同结构参数出口侧向扩张孔的流量系数在不同工况下的变化规律。通过试验研究发现：出口侧向扩张孔圆柱段孔径为0.6 mm时的流量系数比孔径为0.8 mm时大3%；当孔倾角由30°减小至25°时，流量系数随之增大，当倾角继续减小至20°时，流量系数不变；当扩张角由20°增大至40°时，流量系数先增大后减小，且在扩张角为25°时最大；流量系数与次流通道雷诺数成正比，雷诺数越大，流量系数达到极限值所需的压降系数越小，且当压降系数大于0.9后，不同次流雷诺数下的流量系数差别在2%左右。

Abstract

The experimental study on the discharge coefficient of outlet lateral dilated hole was conducted to investigate the trend of discharge coefficients with different structure parameters and aerodynamic parameters.Research showed that the diacharge coefficient of outlet lateral dilated hole cylindrical segment diameter 0.6 mm 3% larger than 0.8 mm.When the hole inclination angle was reduced from 30° to 25°，the discharge coefficient increased，and when the inclination decreased to 20°，the discharge coefficient remains unchanged.When the expansion angle grew from 20° to 40°，the discharge coefficient increased first and then decreased，and reached the maximum value when the expansion angle was 25°.Meanwhile the discharge coefficient was proportional to the secondary flow Reynolds number，and the larger secondary flow Reynolds number indicated the smaller pressure drop needed to reach the limit coefficient value.When the preesure drop was greater than 0.9，the difference of the discharge coefficient at different secondary flow Reynolds number was about 2%.

关键词

Keywords

references

朱惠人 , 许都纯 , 刘松龄 , 等 . 气膜孔形状对流量系数影响的实验研究 [J]. 推进技术 , 1998 , 19 （ 1 ）: 42 ⁃ 45 .

ZHU Huiren , XU Duchun , LIU Songling , et al . The experimental investigation in the effects of film cooling holes shape on discharge coefficient [J]. Journal of Propulsion Technology , 1998 , 19 （ 1 ）: 42 ⁃ 45 . （in Chinese）

GRITSCH M , SCHULZ A , WITTIG S . Discharge coefficient measurements of film⁃cooling holes with expanded exits [J]. Journal of Turbomachinery , 1997 , 120 （ 3 ）: 557 ⁃ 563 .

谢婕 , 张靖周 . 带偏转角气膜出流发散壁冷却特性的数值分析 [J]. 南京航空航天大学学报 , 2013 ， 45 （ 2 ）: 157 ⁃ 161 .

XIE Jie , ZHANG Jingzhou . Numerical simulation on cooling characteristics of effusion wall with deflection film outflow [J]. Journal of Nanjing University of Aeronautics and Astronautics , 2013 ， 45 （ 2 ）: 157 ⁃ 161 . （in Chinese）

杨彬 , 徐国强 , 丁水汀 , 等 . 旋转状态下气膜冷却特性的数值研究 [J]. 航空学报 , 2008 , 29 （ 2 ）: 274 ⁃ 279 .

YANG Bin , XU Guoqiang , DING Shuiting , et al . Numerical study of film cooling characteristics on a rotating turbine blade model [J]. Acta Aeronautica et Astronautica Sinica , 2008 ， 29 （ 2 ）: 274 ⁃ 279 . （in Chinese）

GRITSCH M , SCHULZ A , WITTIG S . Adiabatic wall effectiveness measurements of film⁃cooling holes with expanded exits [R]. ASME Paper 97⁃GT⁃164 , 1997 .

杨卫华 , 马国锋 , 张靖周 , 等 . 气膜冷却孔几何结构对流量系数的影响 [J]. 推进技术 , 2005 , 26 （ 5 ）: 413 ⁃ 416 .

YANG Weihua , MA Guofeng , ZHANG Jingzhou , et al . Influence of geometrical construction of film cooling hole on discharge coefficient [J]. Journal of Propulsion Technology , 2005 , 26 （ 5 ）: 413 ⁃ 416 . （in Chinese）

FORGHAN F . Discharge coefficient of diffusion holes [R]. AAIA⁃95⁃3622 , 1995 .

AN B T , LIU J J . Numerical investigation on diffusion slot hole with various cross⁃sectional end shapes [J]. Journal of Heat Transfer , 2017 , 139 : 091703.1 ⁃ 091703.13 .

SAVARY N , AUPOIX T , DUCHAINE P , et al . Effusion cooling 3D simulations to establish a discharge coefficient correlation [R]. ASME Paper GT2017⁃64264 , 2017 .

张魏，李广超，彭大维，等 . 旋转对带斜肋和双排孔通道孔流量系数影响 [J]. 航空动力学报 , 2010 , 25 （ 6 ）: 1258 ⁃ 1263 .

ZHANG Wei , LI Guangchao , PENG Dawei , et al . Influence of rotation on discharge coefficients of two rows of film holes in channel with rib turbulators [J]. Journal of Aerospace Power , 2010 , 25 （ 6 ）: 1258 ⁃ 1263 . （in Chinese）

李广超 , 朱惠人 , 樊慧明 . 角度和孔间距对双向扩张型孔流量系数影响的实验 [J]. 航空动力学报 , 2009 , 24 （ 3 ）: 499 ⁃ 506 .

LI Guangchao , ZHU Huiren , FAN Huiming . Influence of angles and hole pitches on discharge coefficients of expanded holes at inlet and outlet [J]. Journal of Aerospace Power , 2009 , 24 （ 3 ）: 499 ⁃ 506 . （in Chinese）

宋新伟 , 毛军逵，屠泽灿 , 等 . 双层壳型冲击/气膜综合流量系数实验研究 [J]. 推进技术 , 2012 , 33 （ 6 ）: 875 ⁃ 880 .

SONG Xinwei , MAO Junkui , TU Zecan , et al . Experimental investigations on the discharge coefficient of double⁃decker jet impingement/film structures [J]. Journal of Propulsion Technology , 2012 , 33 （ 6 ）: 875 ⁃ 880 . （in Chinese）

向安定 , 朱惠人 , 刘松龄，等 . 涡轮导向叶片表面气膜孔流量系数的实验研究 [J]. 推进技术 , 2003 , 24 （ 3 ）: 216 ⁃ 219,239 .

XIANG Anding , ZHU Huiren , LIU Songling , et al . Discharge coefficient measurements for film cooling holes on blade surface in a turbine cascade [J]. Journal of Propulsion Technology , 2003 , 24 （ 3 ）: 216 ⁃ 219,239 . （in Chinese）

方韧，林宇震，李彬，等 . 燃烧室多斜孔壁流量系数研究 [J]. 航空动力学报， 1998 , 13 （ 1 ）: 61 ⁃ 64 .

FANG Ren , LIN Yuzhen , LI Bin , et al . Discharge coefficients of inclined multi⁃hole wall cooling in a combustor [J]. Journal of Aerospace Power , 1998 , 13 （ 1 ）: 61 ⁃ 64 . （in Chinese）

曹宗华 , 何跃龙 . 具有复合角的多斜孔板流量系数研究 [J]. 燃气涡轮试验与研究 , 2011 , 24 （ 4 ）: 28 ⁃ 31 .

CAO Zonghua , HE Yuelong . Research on the discharge coefficent of the inclined multi⁃hole plates with compound angle [J]. Gas Turbine Experiment and Research , 2011 , 24 （ 4 ）: 28 ⁃ 31 . （in Chinese）

陈江 , 宋双文 , 陈剑 . 逆向进气复合角发散冷却孔流量系数试验 [J]. 航空动力学报 , 2019 , 34 （ 1 ）: 45 ⁃ 50 .

CHEN Jiang , SONG Shuangwen , CHEN Jian . Experiment of discharge coefficient of counter inlet effusion cooling holes with compound angle [J]. Journal of Aerospace Power , 2019 , 34 （ 1 ）: 45 ⁃ 50 . （in Chinese）

彭中九 . 一种测量火焰筒进气孔流量系数的试验装置及方法： CN107036665A [P]. 2017⁃08⁃11 .

黄开明 , 黄金泉 , 任丹，等 . 涡轴发动机性能参数的等效换算 [J]. 航空动力学报 , 2010 , 25 （ 9 ）: 2036 ⁃ 2040 .

HUANG Kaiming , HUANG Jinquan , REN Dan . Performance parameter equivalent correction of turbo⁃shaft engine [J]. Journal of Aerospace Power , 2010 , 25 （ 9 ）: 2036 ⁃ 2040 . （in Chinese）

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of oil⁃gas matching on combustor instability

Film cooling performance and flow resistance characteristics of single/triple⁃row fan⁃shaped holes based on actual density ratio

Combustor turbine interaction based on scale adaptive simulation

Heat transfer and flow resistance characteristics of multi⁃row jet impingement cooling in double⁃wall cooling structure

Fuel/air mixing characteristics of scramjet combustor based on acetone⁃PLIF technology

Related Author

Li XING

Mingxin ZHENG

Wu LI

Huasheng XU

Yong LIANG

Yinhuai LI

Xiong ZHOU

Hong WEI

Related Institution

Sichuan Gas Turbine Establishment，Aero Engine Corporation of China

Department of Aeronautics and Astronautics，Fudan University

School of Mechanical Engineering，Shanghai Jiao Tong University

Science and Technology on Scramjet Laboratory， China Aerodynamics Research and Development Center

Facility Design and Instrumentation Institute，China Aerodynamics Research and Development Center

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰