Experiment on primary atomization of flat prefilm nozzle under high temperature and high pressure

Juxing ZHANG; Dong DI; Ping ZHANG; Teng ZHANG; Yingwen YAN; Jinghua LI

doi:10.13224/j.cnki.jasp.20210047

Chinese

您当前的位置：

首页 >

文章列表页 >

Experiment on primary atomization of flat prefilm nozzle under high temperature and high pressure

Combustion,Heat and Mass Transfer | 更新时间：2025-04-07

- Experiment on primary atomization of flat prefilm nozzle under high temperature and high pressure
- Journal of Aerospace Power Vol. 37, Issue 1, Pages: 55-66(2022)
- 作者机构：
  
  南京航空航天大学能源与动力学院，南京 210016
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.20210047
  CLC：
- 稿件说明：
移动端阅览
Juxing ZHANG, Dong DI, Ping ZHANG, et al. Experiment on primary atomization of flat prefilm nozzle under high temperature and high pressure[J]. Journal of Aerospace Power, 2022, 37(1): 55-66.
DOI：

Juxing ZHANG, Dong DI, Ping ZHANG, et al. Experiment on primary atomization of flat prefilm nozzle under high temperature and high pressure[J]. Journal of Aerospace Power, 2022, 37(1): 55-66. DOI： 10.13224/j.cnki.jasp.20210047.

摘要

为了深入探究预膜喷嘴燃油初次雾化机理，试验研究了高温高压条件下不同工况参数对平板预膜喷嘴初次雾化特性的影响规律。采用高速摄影可视化技术和马尔文粒度仪获取了预膜平板液膜厚度、液膜波动形态以及索泰尔平均直径（SMD）等雾化特性。利用图像后处理技术提取液膜厚度，试验结果表明：液膜厚度随进气压力、进气温度和进口韦伯数的增加而减小，随燃油流量增加而增加。采用本征正交分解（POD）对液膜波动主要模态时间系数进行快速傅里叶变换，结果表明在相同工况下，液膜波动频率表现出和液膜厚度变化相反的结果。当进气压力改变时，进口韦伯数保持不变，试验结果表明进气压力对最终液滴平均尺寸影响不明显，证实了进口韦伯数是更适合的表征燃油雾化效果的参数，在工况范围内液滴尺寸随着进口韦伯数的增加而减小。

Abstract

In order to deeply explore the primary atomization mechanism of prefilm nozzle，the influences of different working parameters on the primary atomization characteristics of flat prefilm nozzle under high temperature and high pressure were experimentally studied.The atomization characteristics such as liquid film thickness，liquid film fluctuation pattern and Sauter mean diameter （SMD） of the prefilm plate were obtained by high⁃speed photography visualization technology and Malvern particle size analyzer.The film thickness of extraction solution was obtained by image post⁃processing technology.The experimental results showed that the film thickness decreased with the increase of inlet pressure，inlet temperature and inlet Weber number，and increased with the increase of fuel flow rate.Proper orthogonal decomposition （POD） was used to perform fast Fourier transform on the main mode time coefficients of liquid film fluctuation.The experimental results also showed that under the same working conditions，the fluctuation frequency of liquid film presented opposite result with the change of liquid film thickness.When the inlet pressure changed，the inlet Weber number kept unchanged.The experimental results showed that the inlet pressure had no obvious effect on the average size of the final droplet，demonstrating that the inlet Weber number is more suitable for characterizing the fuel atomization effect，and the droplet size decreases with the increase of inlet Weber number.

关键词

Keywords

references

GOSSELIN V , FERRET B , BAZILE R . Coupled study of film and spray on a basic annular prefiming airblast atomizer [R]. Valence,Spain : ILASS⁃28th European Conference on Liquid Atomization and Spray Systems , 2017 .

刘殿春 , 董玉玺 , 尚守堂 , 等 . 航空发动机减排关键技术及应用 [J]. 航空制造技术 , 2008 （ 23 ）: 32 ⁃ 37 .

LIU Dianchun , DONG Yuxi , SHANG Shoutang , et al . Effect of liquid film in air atomizer on atomization performance [J]. Aeronautical Manufalturing Technology , 2008 （ 23 ）: 32 ⁃ 37 . （in Chinese)

赵其寿 , 甘晓华 . 空气雾化喷嘴内液膜对雾化性能的作用 [J]. 推进技术 , 1991 （ 4 ）: 42 ⁃ 48 .

ZHAO Qishou , GAN Xiaohua . Effect of liquid film in air atomization nozzle on atomization performance [J]. Journal ofPropulsion Technology , 1991 （ 4 ）: 42 ⁃ 48 . （in Chinese）

TAREQ M M , DAFSARI R A , JUNG S , et al . Effect of the physical properties of liquid and ALR on the spray characteristics of a pre⁃filming airblast nozzle [J]. International Journal of Multiphase Flow , 2020 ,126:. 124 ⁃ 129 .

LEFEBVRE A H , MILLER D . The development of an airblast atomizer for gas turbine application [R]. Cranfield,UK : Colledge of Aeronautics Cranfield,Colledge of Aeronautics Report Aero 193 , 1966 .

LEFEBVRE A H . Atomization and sprays [M]. New York ： Hemisphere Publishing Corporation , 1988 .

LEFEBVRE A H , BALLAL D R , BAHR D W . Gas turbine combustion:alternative fuels and emissions [J]. Journal of Engineering for Gas Turbines and Power , 2010 , 132 （ 11 ）: 443 ‑ 511 .

ROUDINI M , WOZNIAK G . Experimental investigation of spray characteristics of prefilming airblast atomizers [J]. Journal of Applied Fluid Mechanics , 2018 , 11 （ 6 ）: 1455 ⁃ 1469 .

OKABE T , KATAGATA N , SAKAKI T , et al . Effect of prefilmer edge thickness on breakup phenomena of liquid film in prefilming airblast atomizer [R]. Valencia,Spain : ILASS⁃28th European Conference on Liquid Atomization and Spray Systems , 2017 .

ROUDINI M , WOZNIAK G . Experimental investigation of spray characteristics of pre⁃filming airblast atomizers Ⅱ:influence of liquid properties [J]. Journal of Applied Fluid Mechanics , 2019 , 13 （ 2 ）: 679 ⁃ 691 .

EBNER J . Modelling of shear⁃driven liquid wall films:effect of accelerated air flow on the film flow propagation [J]. Progress in Computational Fluid Dynamics , 2004 , 4 （ 3 ）: 183 ⁃ 190 .

RIZKALLA A A , LEFEBVRE A H . The influence of air and liquid properties on airblast atomization [J]. Journal of Fluids Engineering , 1974 , 97 （ 3 ）: 316 ⁃ 320 .

BECK J E , LEFEBVRE A H , KOBLISH T R . Liquid sheet disintegration by impinging air streams [J]. Atomization and Sprays , 1991 , 1 （ 2 ）: 155 ⁃ 170 .

LEFEBVRE A H , KOBLISH T R , BECK J E . Airblast atomization at conditions of low air velocity [J]. Journal of Propulsion and Power , 2015 , 7 （ 2 ）: 207 ⁃ 212 .

FERNANDEZ V G , BERTHOUMIE P , LAVERGNE G . Liquid sheet disintegration at high pressure:an experimental approach [J]. Comptes Rendus Mecanique , 2009 , 337 （ 6/7 ）: 481 ⁃ 491 .

SATTELMAYER T , WITTIG S . Internal flow effects in prefilming airblast atomizers:mechanisms of atomization and droplet spectra [J]. Journal of Engineering for Power , 1986 , 108 （ 3 ）: 465 ⁃ 472 .

LEFEBVRE A H . Airblast atomization [J]. Progress in Energy and Combustion Science , 1980 , 6 （ 3 ）: 233 ⁃ 261 .

GEPPERTH S , MULLERARMIN , KOCH R , et al . Ligament and droplet characteristics in pre filming airblast atomization [R]. Heidelberg,Germany : ICLASS Triennial International Conference on Liquid Atomization and Spray Systems , 2012 .

何昌升 , 刘云鹏 , 韩宗英 , 等 . 平板式预膜喷嘴初次雾化特性试验 [J]. 航空动力学报 , 2020 , 35 （ 3 ）: 482 ⁃ 495 .

HE Changsheng , LIU Yunpeng , HAN Zhongying , et al . Initial atomization characteristics test of planar prefilm nozzle [J]. Journal of Aerospace Power , 2020 , 35 （ 3 ）: 482 ⁃ 495 . （in Chinese）

GEPPERTH S , GUILDENBECHER D , KOCH R , et al . Prefilming primary atomization:experiments and modeling [R]. Chennai,India : ILASS⁃Europe Conference on Liquid Atomization and Spray Systems , 2010 .

TAIRA K , BRUNTON S L , DAWSON S T M , et al . Modal analysis of fluid flows:an overview [J]. AIAA Journal , 2017 , 55 （ 12 ）: 4013 ⁃ 4041 .

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Comparative experiment of atomization characteristics of RP⁃3 kerosene and surrogate fuel

Reduced order method of blade rubbing system based on proper orthogonal decomposition

Effect of swirler types on spray characteristics of airblast atomizer

Modal decomposition and rapid prediction of shock train oscillation for inlet

Design of improving volumetric efficiency of hypersonic waverider and rapid prediction of flow field

Related Author

Jing LIU

Erjiang HU

Zuohua HUANG

Wen ZENG

Daitong WEI

Xing CHEN

Yugang CHEN

Hongkun LI

Related Institution

State Key Laboratory of Multiphase Flow in Power Engineering，School of Energy and Power Engineering，Xi'an Jiaotong University

Liaoning Key Lab of Advanced Test Technology for Aerospace Propulsion System，School of Aero⁃engine，Shenyang Aerospace University

School of Mechanical Engineering，Dalian University of Technology

Sichuan Gas Turbine Establishment，Aero Engine Corporation of China

School of Power and Energy，Northwestern Polytechnical University

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰