Wear life analysis of angular contact ball bearing in high temperature environment

Rongjun NIU; Zhengjie HAN; Yufei WANG; Hongliang LI; Sier DENG

doi:10.13224/j.cnki.jasp.20210466

Chinese

您当前的位置：

首页 >

文章列表页 >

Wear life analysis of angular contact ball bearing in high temperature environment

Power Transimission | 更新时间：2025-03-14

- Wear life analysis of angular contact ball bearing in high temperature environment
- Journal of Aerospace Power Vol. 37, Issue 8, Pages: 1780-1792(2022)
- 作者机构：
  
  1.河南科技大学机电工程学院，河南洛阳 471003
  2.洛阳轴承研究所有限公司特种轴承事业部，河南洛阳 471039
- 作者简介：
- 基金信息：
- DOI：10.13224/j.cnki.jasp.20210466
  CLC：
- 稿件说明：
移动端阅览
Rongjun NIU, Zhengjie HAN, Yufei WANG, et al. Wear life analysis of angular contact ball bearing in high temperature environment[J]. Journal of Aerospace Power, 2022, 37(8): 1780-1792.
DOI：

Rongjun NIU, Zhengjie HAN, Yufei WANG, et al. Wear life analysis of angular contact ball bearing in high temperature environment[J]. Journal of Aerospace Power, 2022, 37(8): 1780-1792. DOI： 10.13224/j.cnki.jasp.20210466.

摘要

针对高温环境下轴承材料性质和润滑状态变化，造成轴承磨损加剧，过早丧失精度的问题。首先开展高温环境下轴承用材料的摩擦磨损试验，获取材料的磨损系数。在此基础上，考虑温度、润滑、轴承材料属性等对轴承磨损性能的影响，建立高温角接触球轴承磨损模型，通过数值求解探讨工况参数和结构参数等对轴承磨损性能的影响，并评估轴承的磨损寿命。结果表明：对于高温轴承材料无磁合金GH05，在高温300 ℃摩擦状态下平均磨损系数为2.5×10

⁃7

/N；随着载荷、转速、温度的增加，轴承内、外滚道的磨损率均不断增大，其中内圈磨损率大于外圈，内圈磨损特性决定着轴承的磨损寿命；载荷和转速是决定轴承磨损寿命的主要因素，轴承主结构参数对磨损寿命具有重要影响，通过结构优化可提高轴承磨损寿命。

Abstract

In view of the change of bearing material properties and lubrication state under high temperature environment

the bearing wear was aggravated and the accuracy was lost prematurely.Firstly

the friction and wear tests of bearing materials under high temperature environment were carried out to obtain the wear coefficient of the materials.On this basis

the wear model of high temperature angular contact ball bearing was established by considering the effects of temperature

lubrication and bearing material properties on bearing wear performance.Through numerical solution

the effects of load parameters and structural parameters on the wear performance of the bearing were discussed

and the wear life of the bearing was evaluated.The results showed that: for the bearing material non magnetic alloy GH05

the wear coefficient was 2.5×10

-7

/N at 300 ℃.With the increase of load

speed and temperature

the wear rate of inner and outer rings of bearing increased constantly.The wear rate of the inner ring was greater than that of the outer ring.The wear characteristics of the inner ring determine the wear life of the bearing; load and speed are the main factors of determining the bearing wear life.In addition

the main structural parameters of the bearing had an important impact on the wear life.The bearing wear life can be improved through structural optimization.

关键词

Keywords

references

蒋蔚 , 张蕾 , 韩涛 . 高温水轴承的选材与设计 [J]. 轴承 , 2010 （ 1 ）: 15 ⁃ 18 .

JIANG Wei , ZHANG Lei , HAN Tao , et al . Material selection and design of rolling bearings used in high temperature water [J]. Bearing , 2010 （ 1 ）: 15 ⁃ 18 . （in Chinese）

王莹 , 王静波 , 王均安 , 等 . 含硫镍合金的研制及其高温摩擦学特性 [J]. 摩擦学学报 , 1996 , 16 （ 4 ）: 289 ⁃ 297 .

WANG Ying , WANG Jingbo , WANG Junan , et al . Development of nickel containing sulfur alloy and its high temperature tribological properties [J]. Tribology , 1996 , 16 （ 4 ）: 289 ⁃ 297 . （in Chinese）

韩恩厚 , 王俭秋 , 吴欣强 , 等 . 核电高温高压水中不锈钢和镍基合金的腐蚀机制 [J]. 金属学报 , 2010 （ 11 ）: 1379 ⁃ 1390 .

HAN Enhou , WANG Jianqiu , WU Xinqiang , et al . Corrosion mechanisms of stainless steel and nickel base alloys in high temperature high pressure water [J]. Acta Metallurgica Sinica , 2010 （ 11 ）: 1379 ⁃ 1390 . （in Chinese）

刘良勇 , 李建华 , 邓四二 , 等 . 飞轮轴承许用磨损寿命估算算法 [J]. 轴承 , 2011 （ 9 ）: 1 ⁃ 5 .

LIU Liangyong , LI Jianhua , DENG Sier , et al . Evaluation method for allowable wear life of flywheel bearings [J]. Bearing , 2011 （ 9 ）: 1 ⁃ 5 . （in Chinese）

刘良勇 . 动量轮轴承磨损寿命研究 [D]. 河南洛阳 : 河南科技大学 , 2011 .

LIU Liangyong . Study on wear life of momentum wheel bearing [D]. Luoyang Henan : Henan University of Science and Technology , 2011 . （in Chinese）

华显伟 . 惯导轴承动态特性分析 [D]. 河南洛阳 : 河南科技大学 , 2017 .

HUA Xianwei . Dynamic characteristics analysis of the inertial navigation bearing [D]. Luoyang Henan : Henan University of Science and Technology , 2017 . （in Chinese）

YU Guangwei , XIA Wei , SONG Zhuoyuan , et al . Wear⁃life analysis of deep groove ball bearings based on Archard wear theory .[J]. Journal of Mechanical Science and Technology , 2018 , 32 （ 7 ）: 3329 ⁃ 3336 .

LIU C H , CHEN X Y , GU J M , et al . High⁃speed wear lifetime analysis of instrument ball bearings .[J]. Journal of Engineering Tribology , 2009 , 223 （ 3 ）: 497 ⁃ 510 .

姜绍娜 , 陈晓阳 , 顾家铭 , 等 . 陀螺框架轴承摩擦力矩分析 [J]. 机械工程学报 , 2016 , 52 （ 7 ）: 60 ⁃ 68 .

JIANG Shaona , CHEN Xiaoyang , GU Jiaming , et al . Analysis of friction moment of gyroscope frame bearing [J]. Chinese Journal of Applied Mechanics , 2016 , 52 （ 7 ）: 60 ⁃ 68 . （in Chinese）

王燕霜 , 祝海峰 , 刘喆 . 轴连轴承温度场的有限元分析 [J]. 航空动力学报 , 2012 , 27 （ 5 ）： 1146 ⁃ 1152 .

WANG Yanshuang , ZHU Haifeng , LIU Zhe . Finite element analysis on temperature field of bearing with shaft [J]. Journal of Aerospace Power , 2012 , 27 （ 5 ）: 1146 ⁃ 1152 . （in Chinese）

于洁 , 李松生 , 袁伟 , 等 . 考虑热变形影响的主轴轴承动态特性 [J]. 航空动力学报 , 2018 , 33 （ 2 ）: 477 ⁃ 486 .

YU Jie , LI Songsheng , YUAN Wei ， et al . Dynamic property of spindle bearing considering the effect of thermal deformation [J]. Journal of Aerospace Power , 2018 , 33 （ 2 ）: 477 ⁃ 486 . （in Chinese）

ORLOV A V . Influence of wear on the operational stability of ball bearings [J]. Russian Engineering Research , 2011 , 31 （ 11 ）: 1078 ⁃ 1083 .

HOUPERT L . Ball bearing and tapered roller bearing torque:analytical,numerical and experimental results [J]. Tribology Transactions , 2002 , 45 （ 3 ）: 345 ⁃ 353 .

HARRIS T A . Rolling bearing analysis [M]. 4rd ed , New York : Wiley⁃Interscience , 1996 .

MEEKS C R , LONG T . Ball bearing dynamic analysis using computer methods:Part Ⅰ analysis [J]. Journal of Tribology , 1996 , 118 （ 1 ）: 52 ⁃ 58 .

CREŢU S , BERCEA I , MITU N . A dynamic analysis of tapered roller bearing under fully flooded conditions Ⅰ theoretical formulation [J]. Wear , 1995 , 188 （ 1/2 ）: 1 ⁃ 10 .

ZHANG Wenhu , DENG Sier , CHEN Guoding , et al . Impact of lubricant traction coefficient on cage's dynamic characteristics in high⁃speed cylindrical roller bearing [J]. Journal of Tribology , 2017 ,30（ 2 ） 827 ⁃ 835 .

HARRIS T , BARNSBY R M . Life ratings for ball and roller bearings [J]. Journal of Engineering Tribology , 2001 , 215 （ 6 ）: 577 ⁃ 595 .

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Grey relation analysis on nonlinear characteristics and uncertainty characteristics of evolution of rolling bearing vibration performance state

Numerical and experimental research on influence of brush bristle wear on leakage and flow characteristics of brush seal

Fault diagnosis of rolling bearings based on IRCMNDE and NNCHC

Residual life prediction of rolling bearing under multiple stresses

Unknown fault diagnosis of rolling bearing based on improved GWO⁃LightGBM

Related Author

Liang YE

Sier DENG

Yongcun CUI

Wenhu ZHANG

Xiaoxu PANG

Yuzhong FENG

Huan ZHAO

Dan SUN

Related Institution

National United Engineering Laboratory for Advanced Bearing Tribology， Henan University of Science and Technology

Collaborative Innovation Center of Major Machine Manufacturing in Liaoning

Liaoning Key Lab of Advanced Test Technology for Aerospace Propulsion System，School of Aero⁃engine，Shenyang Aerospace University

Key Lab for Power Transmission of Aero Engine，Shenyang Engine Research Institute，Aero Engine Corporation of China

Key Laboratory of Artificial Intelligence of Yunnan Province， Kunming University of Science and Technology

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰