Crack Fault Characteristic Analysis of a Wind Turbine Gearbox with Flash Temperature Considered

ZHANG Xu; ZHONG Jiaxin; LI Wei

doi:10.13433/j.cnki.1003-8728.20220212

Chinese

您当前的位置：

首页 >

文章列表页 >

Crack Fault Characteristic Analysis of a Wind Turbine Gearbox with Flash Temperature Considered

更新时间：2026-07-10

- Crack Fault Characteristic Analysis of a Wind Turbine Gearbox with Flash Temperature Considered
- Mechanical Science and Technology for Aerospace Engineering Vol. 43, Issue 2, Pages: 187-196(2024)
- 作者机构：
  
  1. 天津工业大学天津市现代机电装备技术重点实验室,天津,300387
  2. 天津城建大学能源与安全工程学院,天津,300384
- 作者简介：
- 基金信息：
- DOI：10.13433/j.cnki.1003-8728.20220212
  CLC：
- Online First：01 February 2024，
  
  Published：2024
- 稿件说明：
移动端阅览
ZHANG Xu, ZHONG Jiaxin, LI Wei. Crack Fault Characteristic Analysis of a Wind Turbine Gearbox with Flash Temperature Considered[J]. Mechanical Science and Technology for Aerospace Engineering, 2024, 43(2): 187-196.
DOI：

ZHANG Xu, ZHONG Jiaxin, LI Wei. Crack Fault Characteristic Analysis of a Wind Turbine Gearbox with Flash Temperature Considered[J]. Mechanical Science and Technology for Aerospace Engineering, 2024, 43(2): 187-196. DOI： 10.13433/j.cnki.1003-8728.20220212.

摘要

为了研究齿面闪温对风电齿轮箱裂纹故障时系统动力学响应的影响，利用Blok闪温理论分析齿轮啮合时的齿面温度，应用热变形公式计算齿廓形变，进而通过Hertz接触理论获得计及齿面闪温影响的轮齿刚度。考虑齿面闪温、阻尼、时变啮合刚度、综合啮合误差和齿侧间隙，建立含有高速级齿轮齿根裂纹的齿轮箱扭转动力学模型。通过时域图、频谱图、相图和Poincaré截面分析不同裂纹长度下系统振动特性随齿面闪温变化的规律，并比较裂纹故障仿真与实验的时频域结果。结果表明：齿面闪温使时域图上裂纹产生的冲击幅值增大、频域图中故障边频结构更为复杂、相图曲线向外扩展以及Poincaré截面离散点增多，且变化均随裂纹长度的增加越为明显。研究结论可为齿轮裂纹故障状态的诊断与监测提供依据。

Abstract

In order to study the influence of the flash temperature on the crack fault characteristic of a wind turbine gearbox

the temperature and profile deformation of the tooth are calculated using the Blok flash temperature theory and thermal deformation formula

respectively

and the tooth stiffness considering the flash temperature is obtained using the Hertz contact theory. For the gearbox with crack fault occurred on the tooth root of the high-speed gear

the torsional dynamic model is established considering flash temperature

damping

meshing stiffness

transmission error and backlash. The variation laws of the vibration characteristics with flash temperature are investigated under different crack conditions through time domain

frequency spectrum

phase diagram and Poincaré section

and the numerical results in the time-frequency domain are compared with those of the test without considering the flash temperature. The results show that the flash temperature makes the impact amplitude from the crack in the time domain increase

the fault side frequency be more complex

the phase diagram expand and the number of discrete points in Poincaré section increase

and the changes are more obvious with increasing the crack length. The research provides the basis for diagnosing and monitoring the gear crack fault state.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Gait Design and Motion Analysis of Hexapod Bionic Robots

Study on DCS-YOLOv8 Algorithm of Steel Surface Defect Detection

Vibration Characteristics Analysis of Gear Systems with Cracks at Tooth Root

Discrete Active Disturbance Rejection Control of Delta Robots Under High Speed Motion

Research on Continuous Obstacle Avoidance Trajectory Planning and Tracking Control Strategies for Low Speed Intelligent Vehicles with Different Road Curvature Changes

Related Author

No data

Related Institution

No data

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰