金属粉体爆炸火焰发射光谱与爆炸压力耦合研究

孟祥豹; 袁军; 宋世泽民; 郭惟宵; 李登钊; 刘珊珊

doi:10.13637/j.issn.1009-6094.2025.103010.13637/j.issn.1009-6094.2025.1030

Chinese

您当前的位置：

首页 >

文章列表页 >

金属粉体爆炸火焰发射光谱与爆炸压力耦合研究

更新时间：2026-04-17

- 金属粉体爆炸火焰发射光谱与爆炸压力耦合研究
- Vol. 26, Issue 4, Pages: 1266-1274(2026)
- 作者机构：
  
  1. 山东科技大学安全与环境工程学院
  2. 青岛市生产安全火灾重大事故智能控制工程研究中心
  3. 山东科技大学公共安全研究院
- 作者简介：
- 基金信息：
- DOI：10.13637/j.issn.1009-6094.2025.103010.13637/j.issn.1009-6094.2025.1030
  CLC： X932
- Published：2026
- 稿件说明：
移动端阅览
[1]孟祥豹,袁军,宋世泽民,等.金属粉体爆炸火焰发射光谱与爆炸压力耦合研究[J].安全与环境学报,2026,26(04):1266-1274.
[1]孟祥豹,袁军,宋世泽民,等.金属粉体爆炸火焰发射光谱与爆炸压力耦合研究[J].安全与环境学报,2026,26(04):1266-1274. DOI： 10.13637/j.issn.1009-6094.2025.103010.13637/j.issn.1009-6094.2025.1030.

DOI：10.13637/j.issn.1009-6094.2025.1030.

摘要

以爆炸火焰发射光谱与爆炸压力耦合机制为切入点，分别选取粒径10～75μm铝粉、镁粉及铝镁合金粉，通过光纤光谱仪与20 L粉尘爆炸试验仪同步采集光谱与压力数据，揭示了不同金属粉体发射光谱峰位、强度以及特征光谱出现前后爆炸压力及压力上升速率变化规律。结果表明：铝粉爆炸AlO自由基在511 nm处呈现主特征峰，区别于燃烧过程486.3 nm峰，可作为铝粉爆炸强度的特异性标识；镁粉在500 nm(MgO)和518 nm(Mg原子)处呈现双峰特征，20μm粉体518 nm峰强度较50μm提升40%;爆炸压力大于0.2 MPa后，自由基先行响应，压力出现滞后效应，光谱强度峰值普遍先于压力峰值10～50 ms。

Abstract

To facilitate the timely detection of metal powder explosion accidents and provide a theoretical foundation for the rapid response of explosion suppression equipment

this study explored the dynamic coupling relationship between flame emission spectra and pressure parameters during explosions of aluminum powder

magnesium powder

and aluminum-magnesium alloy powder(particle size: 10-75 μm). Experiments were conducted using an Andor Shamrock 500i fiber optic spectrometer(acquisition rate: 143 frames per second

grating: 500 nm) in conjunction with a 20 L powder explosion tester. The powder samples were dispersed into a container that had been pre-evacuated to 32 kPa

with a 60 ms ignition delay. Spectral data were collected at a distance of 400 mm from the observation window. Key results revealed distinct spectral features: aluminum powder explosi

ons exhibited a dominant AlO characteristic peak at 511 nm

in contrast to the 486.3 nm peak observed during combustion. The peak intensity was inversely proportional to particle size

with intensity values around 6 000 for 10 μm particles compared to approximately 2 000 for 50 μm particles. In magnesium powder explosions

a doublet peak was noted at 500 nm(MgO) and 518 nm(atomic Mg)

with the intensity of the 518 nm peak being 40% higher for 20 μm powder compared to 50 μm powder. Aluminum-magnesium alloy powder explosions exhibited a prominent magnesium peak at 518 nm

with no detectable AlO emission. Analysis revealed that the spectral peaks consistently appeared 10-50 ms before the maximum pressure(p

max

). Notably

we identified a fixed sequence: the maximum pressure rise rate(dp/dt)

max

occurred first

followed by the spectral peak

and finally p

max

. Additionally

the pressure rise rate significantly decreased with increasing particle size

for example

from 10 MPa/s for 10 μm aluminum to 2.4 MPa/s for 50 μm aluminum. Above 0.2 MPa pressure

the radical spectral responses were rapid

while the pressure rise exhibited a lag due to gas expansion. This study identifies 511 nm(aluminum powder)

500 nm(magnesium powder)

and 518 nm(aluminum-magnesium alloy powder) as optimal detection wavelengths. The strong correlation between spectral intensity and pressure during the rising phase

along with the lead time of(dp/dt)

max

and spectral peaks over p

max

establishes a foundation for early explosion detection.

关键词

Keywords

references

张晓蕾，陈刚，徐帅，等.中美粉尘爆炸事故统计和管理体系对比研究[J].安全与环境学报，2023,23(8):2769-2779.ZHANG X L,CHEN G,XU S,et al.Comparative study on dust explosion accident statistics and management system between China and the United States[J].Journal of Safety and Environment,2023,23(8):2769-2779.

CHEN Z H,FAN B C,JIANG X H.Suppression effects of powder suppressants on the explosions of oxyhydrogen gas[J].Journal of Loss Prevention in the Process Industries,2006,19(6):648-655.

CHEN H Y,ZHANG Y S,LIU H,et al.Cause analysis and safety evaluation of aluminum powder explosion on the basis of catastrophe theory[J].Journal of Loss Prevention in the Process Industries,2018,55:19-24.

ZHANG B,HUANG C Y,LIU L J,et al.Experimental investigations on synergistic inhibition of aluminum hydroxide and aerosil on ignition sensitivity of Niacin dust[J].Journal of the Taiwan Institute of Chemical Engineers,2021,122:23-31.

DAI L L,LIN H,KANG W,et al.Inhibition of different types of inert dust on aluminum powder explosion[J].Chinese Journal of Chemical Engineering,2020,28(7):1941-1949.

SUN W N,LIU Y H,WANG F,et al.A study on flame detection method combining visible light and thermal infrared multimodal images[J].Fire Technology,2024,61(4):1-22.

YAN K,MENG X B.An investigation on the aluminum dust explosion suppression efficiency and mechanism of a NaHCO3/DE composite powder[J].Advanced Powder Technology,2020,31(8):3246-3255.

XIONG X Y,GAO K,JI C Q,et al.Study on the characteristics parameters of magnesium dust explosion suppression by various inert gases[J].Journal of Loss Prevention in the Process Industries,2024,87:105242.

MA X S,MENG X B,LI Z Y,et al .Study of the influence of melamine polyphosphate and aluminum hydroxide on the flame propagation and explosion overpressure of aluminum magnesium alloy dust[J].Journal of Loss Prevention in the Process Industries,2020,68:104291.

LU Z K,GAO W,JIANG H P,et al.Vented flame quenching mechanism and overpressure prediction model in aluminum dust explosions[J].International Journal of Thermal Sciences,2025,210:109623.

YAN K,MENG X B,WANG Z,et al.Inhibition of aluminum powder explosion by a NaHCO3/Kaolin composite powder suppressant[J].Combustion Science and Technology,2020,194(4):1-17.

MITTAL M.Explosion characteristics of micron- and nano-size magnesium powders[J].Journal of Loss Prevention in the Process Industries,2014,27:55-64.

赵云龙.基于紫外探测的井下阻隔防爆系统的研究[D].徐州：中国矿业大学，2016.ZHAO Y L.Research on mine barrier Explosion-proof system based on UV detection[D].Xuzhou:China University of Mining and Technology,2016.

周立群.瓦斯抑爆高速红外探测系统的研究[D].哈尔滨：哈尔滨工程大学，2014.ZHOU L Q.Study on high-speed IR detecting system for inhibiting gas explosion[D].Harbin:Harbin Engineering University,2014.

薛莹，赵志鹏，刘建翔，等.基于红紫外光电传感器的多波段火焰探测方法研究[J].消防科学与技术，2024,43(3):384-388.XUE Y,ZHAO Z P,LIU J X,et al.Research on multiband flame detection method based on red UV photoelectric sensors[J].Fire Science and Technology,2024,43(3):384-388.

李孝斌.矿井瓦斯爆炸感应期内反应动力学分析及光学特征研究[D].西安：西安科技大学，2010.LI X B.Analysis of Reaction dynamics and study on optical characteristic of gas explosion in induction period[D].Xi'an:Xi'an University of Science and Technology,2010.

李孝斌.矿井瓦斯爆炸感应期内光学特征研究[D].西安：西安科技大学，2006.LI X B.Study on optical characteristic of gas explosion in induction periods[D].Xi'an:Xi'an University of Science and Technology,2006.

NITTA K,KANNO S,OKA Y.Experimental study on responsiveness of multi-spectrum infrared flame detectors to diffuse flames partially hidden by obstacles installed in oil and gas processing facilities[J].Journal of Loss Prevention in the Process Industries,2024,91:105378.

ZHOU Y N,LIU J Z,LIANG D L,et al.Effect of particle size and oxygen content on ignition and combustion of aluminum particles[J].Chinese Journal of Aeronautics,2017,30(6):1835-1843.

BADIOLA C,GILL J R,DREIZIN L E.Combustion characteristics of micron-sized aluminum particles in oxygenated environments[J].Combustion and Flame,2011,158(10):2064-2070.

GLUMAC N,KRIER H,BAZYN T,et al.Temperture measurements of aluminum particles burning in carbon dioxide[J].Combustion Science and Technology,2005,177(3):485-511.

彭志敏，杨乾锁，刘春，等.激波管壁AlO自由基B2Σ+-X2Σ+和C2Πr-X2Σ+带系辐射光谱的研究[J].光谱学与光谱分析，2010,30(4):865-868.PENG Z M,YANG Q S,LIU C,et al.Investigation on spectrum of B2Σ+-X2Σ+ and C2Πr-X2Σ+ bands of AlO radical in shock tube[J].Spectroscopy and Spectral Analysis,2010,30(4):865-868.

冯运超.高温燃气中铝/铝镁合金颗粒点火燃烧过程研究[D].长沙：国防科技大学，2019.FENG Y C.Investigation on the ignition and combustion of aluminum/aluminum magnesium alloy particle in hot gas[D].Changsha:National University of Defense Technology,2019.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

面向复杂施工环境的人员防护装备穿戴识别方法对比研究

基于YOLOv10n-knot的电力安全带挂点检测算法

改进型金字塔解析网络在矿区浮石识别中的应用研究

沿空留巷采空区注氮防灭火参数优化

极端天气下城市新型电力系统风险评估方法研究

Related Author

荣耀

于平林

李永威

王培

丁海滨

郑艳梅

张欣

芦碧波

Related Institution

江西省交投养护科技集团有限公司

华东交通大学山区土木工程安全与韧性全国重点实验室

河南理工大学计算机科学与技术学院

西安建筑科技大学资源工程学院

国能神东煤炭集团地测公司

AI问答

Postal code：100079
Tel：（010）53879206 Email：tmw@bjxintong.com.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09082226号-64 京公网安备11010602201714号
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰