基于电荷平衡的DCM转换器差分外推控制研究

王宛阳; 吕典; 邹志革; 闵闰; 童乔凌

Chinese

您当前的位置：

首页 >

文章列表页 >

基于电荷平衡的DCM转换器差分外推控制研究

更新时间：2026-09-04

- 基于电荷平衡的DCM转换器差分外推控制研究
- Study of CBP-based differential extrapolation control for DCM converter
- 微电子学与计算机 2021年38卷第5期页码：19-24
- 作者机构：
  
  华中科技大学光学与电子信息学院,湖北,武汉,430074
- 作者简介：
- 基金信息：
  
  国家自然科学基金项目 61701184国家自然科学基金项目 61640311
- DOI：
  中图分类号：
- 纸质出版：2021
- 稿件说明：
移动端阅览
王宛阳, 吕典, 邹志革, 闵闰, 童乔凌. 基于电荷平衡的DCM转换器差分外推控制研究[J]. 微电子学与计算机, 2021, 38(5): 19-24.

WANG Wan-yang, LYU Dian, ZOU Zhi-ge, et al. Study of CBP-based differential extrapolation control for DCM converter[J]. 2021, 38(5): 19-24.
王宛阳, 吕典, 邹志革, 闵闰, 童乔凌. 基于电荷平衡的DCM转换器差分外推控制研究[J]. 微电子学与计算机, 2021, 38(5): 19-24. DOI：

WANG Wan-yang, LYU Dian, ZOU Zhi-ge, et al. Study of CBP-based differential extrapolation control for DCM converter[J]. 2021, 38(5): 19-24. DOI：

摘要

为了提升电感电流断续模式(discontinuousconductionmode，DCM)下开关电源转换器的瞬态响应性能，提出了一种基于电荷平衡原理和平均电流的差分外推控制方法.以Boost转换器为例，该方法利用采样的输出电压进行差分外推(differential extrapolation，DE)，预估负载对电荷的影响，进而通过平衡算法得到电流控制量.相较传统的使用电荷平衡原理的电流控制方法(charge balance principle based current control，CBPC)，差分外推控制方法缩短了负载估计的延迟，减小了负载估计误差，为DCM转换器的控制设计提供了有效参考.通过Boost样机实验对比了CBPC控制与DE控制在输入、负载和参考电压发生扰动时的响应波形，结果表明，本文提出的DE控制对扰动的响应更加优异.

Abstract

In order to improve the transient response of the switching converter indiscontinueous conducting mode (DCM)

a differential extrapolation control method is proposed based on the charge balance principleusing Boost convertor as an example. This method uses the variation of sampled output voltage to carry on an extension

which indicates the load influence on the output capacitor charge

and then obtains the current control quantity by the balance algorithm. Compared with the traditional charge balance principle based current control (CBPC)

this method reduces control delay and the transient instability caused by the approximate of load information.The method also providesreferencefor thedesign of DCM controllers.The response waveforms of CBPC control and DE control are comparedby Boost prototype

when input

load and reference voltage are disturbed. Among these experiments

the response is better when using DE control proposed in this paper.

关键词

Keywords

references

QIU Y, CHEN X Y, LIU H. Digital average current-mode control using current estimation and capacitor charge balance principle for DC-DC converters operating in DCM[J]. IEEE Transactions on Power Electronics, 2010, 25(6): 1537-1545. DOI:10.1109/TPEL.2010.2040089.

CHEN C, TONG Q L, MIN R, et al. Sensorless predictive current control with a charge balance current estimator for boost converters based on discrete-time model considering current ripple[J]. IET Power Electronics, 2018, 11(13): 2063-2071. DOI:10.1049/iet-pel.2018.5051.

ZHANG X F, MIN R, LYU D, et al. Current tracking delay effect minimization for digital peak current mode control of DC-DC boost converter[J]. IEEE Transactions on Power Electronics, 2019, 34(12): 12384-12395. DOI:10.1109/TPEL.2019.2905864.

HARIHARAN K, KAPAT S, MUKHOPADHYAY S. Constant on-time multi-mode digital control with superior performance and programmable frequency[C]//2019 IEEE Applied Power Electronics Conference and Exposition (APEC). Anaheim: IEEE, 2019: 1344-1350. DOI: 10.1109/APEC.2019.8722156.

MIN R, TONG Q L, ZHANG Q, et al. Digital sensorless current mode control based on charge balance principle and dual current error compensation for DC-DC converters in DCM[J]. IEEE Transactions on Industrial Electronics, 2016, 63(1): 155-166. DOI:10.1109/TIE.2015.2464192.

MIN R, ZHANG X F, LYU D, et al. Superposed compensation strategy to optimize load/line transient response and reference tracking for discontinuous conduction mode boost converter[J]. IEEE Transactions on Industrial Informatics, 2019, 15(5): 2512-2522. DOI:10.1109/TⅡ.2018.2871359.

WANG L, WU Q H, TANG W H, et al. Energy balance analysis and control for boost converters[C]//IECON 2017 - 43rd Annual Conference of the IEEE Industrial Electronics Society. Beijing: IEEE, 2017: 8194-8200. DOI: 10.1109/IECON.2017.8217438.

BAZDARICR, MATKO D, LEBAN A, et al. Fuzzy model predictive control of a DC-DC boost converter based on non-linear model identification[J]. Mathematical and Computer Modelling of Dynamical Systems, 2017, 23(2): 116-134. DOI:10.1080/13873954.2016.1232283.

陈晨, 童乔凌, 闵闰, 等. 基于RLS的Boost转换器在线多参数辨识研究[J]. 微电子学与计算机, 2017, 34(5): 100-103. DOI: 100 CHENC, TONG Q L, MIN R, et al. Study of RLS-based online multiparameter identification for boost converter[J]. Microelectronics % Computer, 2017, 34(5): 100-103. DOI: 100

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

基于多尺度融合与小目标增强的航拍车辆检测算法

大模型发展综述：从BERT到Deepseek的技术演进

低功耗设计的双链电源关断策略的实现与验证

基于改进RT-DETR的航拍小目标检测算法

超低功耗实时时钟电路的设计