Aiming at the non-ideal connection of multi-board interconnection of PCB and the IR Drop loss of multi-power supply voltage

a power distribution network based on PCB is proposed.The simulation analysis of the power supply network from the 12 V input voltage of the base plate step by step down to the supply voltage of the main chip of the core board 1.1 V and 1.5 V.It mainly involves three aspects:DC voltage Drop

the IR Drop of the main control chip is reduced from 226.24 mV to 41.10 mV by choosing inductors with lower ESR and broadening the copper covering area of the power pin of the main control chip.Current density

the current density obtained by simulation is 70.40 A/mm2

less than 100 A/mm2.The through-hole flow capacity

increase the number of through-holes

so that the current at the through-hole decreases from the highest 1.172 A to the highest 0.556 A.The simulation results show that this method can effectively reduce the potential voltage drop loss risk of multi-board connected PCB circuit and improve the reliability and stability of power system.