ZHAO Chuan, YU Suihuai, CHEN Chen, et al. Research on the control handing comfort evaluation model for standing posture[J]. 2020, 52(5): 194-200.DOI: 10.11918/201901045.
结果表明:T-S FNN模型具有较小的均方根误差(1.2 VS 4.5).最后随机选取15组不同操纵任务进行检验
结果表明:该方法的预测值和实际值相关性系数为0.962(P<0.01)
与快速上肢评估(RULA)计算结果的相关性系数为0.833(P<0.01)
与工作体位分析系统(OWAS)计算结果的相关性系数为0.694(P<0.01)
说明该方法能够良好的反应真实结果.
Abstract
Good control handing comfort not only reduces fatigue but also improves efficiency. Aiming at the uncertainty and fuzziness of control handing comfort evaluation
this study builds up a control handing comfort evaluation model for standing posture based on Takagi-Sugeno Fuzzy Neural Network (T-S FNN). Training and testing data were collected during the experiment. Twenty adult test subjects were asked to complete 100 different operation tasks. Test subjects’ joint angle
foot pressure distribution
anthropometric dimensions
target position
and subjective comfort rating were collected during the experiment. The proposed model was trained using 90% of the data obtained from the experiment and was verified by the remaining 10% experiment data. It was then compared with the subjective comfort rating estimated by BP Neural Network. Results show that the proposed model had smaller root mean square error than BP Neural Network (1.2 vs. 4.5). Subsequently
15 groups of different tasks were randomly selected to further test this model. Results show that the correlation coefficients between the value obtained by this model and the actual value
and those obtained by the Rapid Upper Limb Assessment (RULA) and the Ovako Working Posture Analysing System (OWAS) were 0.962 (P<0.01)
0.833 (P<0.01)
and 0.694 (P<0.01)
respectively. This study demonstrates that the proposed model is effective in estimating control handing comfort.