非均匀速度来流条件下液体射流喷雾特性

孔祥壮; 何悟; 郭志辉

doi:10.13224/j.cnki.jasp.20210151

Chinese

您当前的位置：

首页 >

文章列表页 >

非均匀速度来流条件下液体射流喷雾特性

燃烧、传热、传质 | 更新时间：2025-04-07

- 非均匀速度来流条件下液体射流喷雾特性
- Spray characteristics of liquid jet in nonuniform crossflow
- 航空动力学报 2022年37卷第3期页码：534-544
- 作者机构：
  
  北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室，北京 100191
- 作者简介：
  
  孔祥壮（1996-），男，硕士生，主要从事航空发动机燃烧室雾化研究。
- 基金信息：
  
  国家科技重大专项（2017⁃Ⅲ⁃0008⁃0034）
- DOI：10.13224/j.cnki.jasp.20210151
  中图分类号：
- 稿件说明：
移动端阅览
孔祥壮, 何悟, 郭志辉. 非均匀速度来流条件下液体射流喷雾特性[J]. 航空动力学报, 2022,37(3):534-544.

Xiangzhuang KONG, Wu HE, Zhihui GUO. Spray characteristics of liquid jet in nonuniform crossflow[J]. Journal of Aerospace Power, 2022, 37(3): 534-544.
孔祥壮, 何悟, 郭志辉. 非均匀速度来流条件下液体射流喷雾特性[J]. 航空动力学报, 2022,37(3):534-544. DOI： 10.13224/j.cnki.jasp.20210151.

Xiangzhuang KONG, Wu HE, Zhihui GUO. Spray characteristics of liquid jet in nonuniform crossflow[J]. Journal of Aerospace Power, 2022, 37(3): 534-544. DOI： 10.13224/j.cnki.jasp.20210151.

摘要

实验研究了非均匀速度来流条件下液体横向射流喷雾特性。实验利用多孔板实现速度的不均匀，应用片光照相得到喷雾中心截面照片，使用相位多普勒粒子分析仪（PDPA）测量液滴的直径和速度。实验结果表明：在非均匀速度来流中，射流的弯曲和破碎机理有所不同，导致穿透深度和雾化特性发生改变。与均匀速度来流相比，正速度梯度来流时射流穿透深度更大，液柱破碎高度增大，浓度场分布更加均匀，射流呈现平抛形态；负速度梯度时喷雾场整体内移，浓度场呈明显分层结构，射流尾迹区增长，射流为坍塌形态。初步提出适用于非均匀速度来流条件下的射流穿透深度经验公式。非均匀速度来流可以改善雾化及均匀度，其中负速度梯度来流时液雾的索太尔平均直径（SMD）最小。

Abstract

Spray characteristics of liquid jet in nonuniform velocity distribution crossflow were experimentally studied.The nonuniform velocity distribution was produced by perforated plates，the images of spray were captured with a light sheet and a single lens reflex camera，and a phase Doppler particle analyzer （PDPA） was used to measure droplets diameter and velocity.The experimental results indicated that，in the nonuniform crossflow，the bending state and breakup regime of each jet section were different，resulting in the difference of penetration and spray characteristics.Compared with uniform corssflow，the jets penetrated further into the crossflow when the column breakup height increased，and the concentration distribution was more uniform when the velocity distribution was in positive gradient，in addition，the jet presented a flat thrown profile.When the velocity gradient was negative，the spray field moved inward and presented a stratified structure，the jet wake region elongated，and the profile of jet was in collapse state.Correlations of a liquid jet for nonuniform crossflow are presented.Nonuniform crossflow can improve atomization and uniformity，and Sauter mean diameter （SMD） reaches a minimum value when the velocity distribution is negative gradient.

关键词

Keywords

references

LOVETT J , BROGAN T , PHILIPPONA D , et al . Development needs for advanced afterburner designs [R].AIAA 2004 ⁃4192 , 2004 .

EBRAHIMI H . Overview of gas turbine augmentor design , operation , and combustion oscillation [R].AIAA 2006 ⁃4916 , 2006 .

FOUST M , THOMSEN D , STICKLES R , et al . Development of the GE aviation low emissions TAPS combustor for next generation aircraft engines [R].AIAA 2012 ⁃0936 ， 2012 .

WU P K , KIRKENDALL K A , FULLER R P , et al . Breakup processes of liquid jets in subsonic crossflows [J]. Journal of Propulsion and Power , 1997 , 13 （ 1 ）： 64 ⁃ 73 .

BIROUK M , AZZOPATDI B J , STABLER T . Primary break⁃up of a viscous liquid jet in a cross airflow [J]. Particle and Particle Systems Characterization ， 2003 , 20 （ 4 ）: 283 ⁃ 289 .

BROUMAND M , BIROUK M . Liquid jet in a subsonic gaseous crossflow:recent progress and remaining challenges [J]. Progress in Energy and Combustion Science , 2016 , 57 : 1 ⁃ 29

林宇震 , 李林 , 张弛 , 等 . 液体射流喷入横向气流混合特性研究进展 [J]. 航空学报 , 2014 , 35 （ 1 ）: 46 ⁃ 57 .

LIN Yuzhen , LI Lin , ZHANG Chi , et al . Progress on the mixing of liquid jet injected into a crossflow [J]. Acta Aeronautica et Astronautica Sinica , 2014 , 35 （ 1 ）: 46 ⁃ 57 . （in Chinese）

ELSHAMY O , TAMBE S , CAI J , et al . Structure of liquid jets in subsonic crossflow at elevated ambient pressures [R]. AIAA⁃2006⁃1224 , 2006 .

LAKHAMRAJU B . Liquid jet breakup studies in subsonic airstream at elevated temperatures [D]. Lincinnati,Ohio,US : University of Cincinnati , 2005 .

STENZLER J N , LEE J G , SANTAVICCA D A , et al . Penetration of liquid jets in a crossflow [R]. AIAA⁃2013⁃1327 , 2003 .

TAMBE S B , ELSHAMY O JENG S M . Liquid jets injected transversely into a shear layer [R]. Reno,Nevada,US : 45th AIAA Aerospaces Science Meeting and Exhibit ， 2013 .

TAMBE S B , ELSHAMY O , JENG S M . Spray properties of liquid jets injected transversely into a shear layer [R]. Cincinnati，US ： 43rd AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit , 2013 .

BECKER J , HASSA C . Liquid fuel placement and mixing of generic aeroengine premix module at different operating conditions [J]. Journal of Engineering for Gas Turbines and Power , 2003 , 125 （ 4 ）: 901 ⁃ 908 .

LIN C K , KENNEDY J P , JACKSON T A . A review of penetration heights of transverse liquid jets in high⁃speed flows [R]. Lavergne，France : 15th Annul Conference on Liquid Atomization and Spray System ， 1999 .

WANG Q , MONDRAGON U M , BROWN C T , et al . Characterization of trajectory,break point,and break point dynamics of a plain liquid jet in a crossflow [J]. Atomization and Sprays , 2011 , 21 （ 3 ）: 203 ⁃ 219 .

ESLAMIAN M , AMIGHI A , ASHGRIZ N . Atomization of liquid jet in high⁃pressure and high temperature subsonic crossflow [J]. AIAA Journal , 2014 , 52 （ 7 ）: 1374 ⁃ 1385 .

RANGER A A , NICHOLLS A J . Aerodynamic shattering of liquid drops [J]. AIAA Journal , 1969 , 7 （ 2 ）: 285 ⁃ 290 .

WU P K , FULLER R P , KIRKENDALL K A , et al . Spray structures of liquid jets atomized in subsonic crossflows [J]. Journal of Propulsion and Power , 1998 , 14 （ 2 ）: 173 ‑ 182 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

基于气助雾化喷射的柴油喷雾特性数值模拟

组合式弹性金属密封泄漏特性实验研究与结构优化

基于三维接触摩擦单元的套齿连接解析建模研究

考虑多源不确定性的复合材料风扇叶片高周疲劳失效概率评估

基于自适应MOMEDA滚动轴承故障特征提取方法